Characterization and catalytic performance of supported molybdophosphoric acid catalysts for the oxidation of propylene to acetone

Mingshi Li,Jianyi Shen,Xin Ge,Xi Chen
DOI: https://doi.org/10.1016/S0926-860X(00)00597-4
2001-01-01
Abstract:The oxidation of propylene to acetone was studied over supported molybdophosphoric acid catalysts at 463K in the presence of water. Raman spectroscopy revealed that molybdophosphoric acid retained its Keggin structure when supported on SiO2 while it decomposed to MoO3 when supported on γ-Al2O3. Microcalorimetric adsorption of NH3 showed that the H3PMo12O40/SiO2 catalyst exhibited strong acidity (152kJ/mol) and the MoO3/γ-Al2O3 catalyst prepared from molybdophosphoric acid displayed fairly strong acidity (137kJ/mol). FTIR showed that both Brönsted and Lewis acid sites were present on the surface of the two catalysts. Since the reaction can be taken as the coupling of the hydration of propylene and the oxydehydrogenation of propanol, both acid and redox sites are needed to form the active catalysts. However, the H3PMo12O40/SiO2 catalyst showed almost no activity while the MoO3/γ-Al2O3 catalyst exhibited fairly good activity. Thus, the hydration of propylene may not be rate-limiting for the reaction on these catalysts. Microcalorimetric adsorption of propylene and acetone demonstrated that adsorption of propylene and desorption of acetone might not be rate-limiting, either. It can be concluded that the abstraction of the α-H of surface isopropoxy groups may be the rate-limiting step.
What problem does this paper attempt to address?