Abstract:Understanding the initiating and suppression mechanisms of existing defects are the key to optimizing the ultra-precision grinding process of hard and brittle materials. This paper discusses the effects of grinding damage on material removal mechanism from the perspectives of residual scratch depth, scratch morphology and normal scratching force, through conducting the contrast variable-depth nano-scratch experiment on polished and ground monocrystalline silicon and establishing the single grain scratching Smoothed Particle Hydrodynamics (SPH) model. The experimental and simulation results show that radial crack on ground silicon surface is almost invisible due to the existence of grinding marks, which indicates that it is difficult to judge the ductile brittle transition (DBT) point by the traditional method of observing cracks. With the increase of penetration depth, pop-in will occur in the residual scratch depth of polished and ground silicon, indicating that the material removal mode has transformed, which provides an important basis for judging the DBT point. The DBT critical normal scratching force (38.93 mN) and residual scratch depth (−0.14 μm) of ground silicon are much higher than those of polished silicon, implying ground silicon is easier to achieve ductile processing. Meanwhile, when the penetration depth is the same, compared to polished silicon, the normal scratching force of ground silicon is generally larger. Finally, a single grain scratching SPH model of pre-stressed silicon is established. And the simulated phenomenon and conclusions are consistent with the experiment, which proves that the surface compressive stress is an important factor that causes the removal characteristics of ground silicon to be different from polished silicon. This study provides a theoretical basis for understanding the ultra-precision grinding removal mechanism of hard and brittle materials.

TEM Observation on the Ground Damage of Monocrystalline Silicon Wafers

Analysis on Ground Surface Damage of Quartz Fiber-Reinforced Quartz Composites

Observation in the Surface Roughness of Silicon Wafer During Semi-Fixed Abrasive Machining with Large Grains

Ductile deformation and subsurface damage evolution mechanism of silicon wafer induced by ultra-precision grinding process

Surface damage in wire-cut silicon wafers

Method of Damage Characterization of Engineering Ceramics Grinding Surface

Analytical modeling of grinding-induced subsurface damage in monocrystalline silicon

Subsurface damages beneath fracture pits of reaction-bonded silicon carbide after ultra-precision grinding

Sub-surface Damage of Ultra-Thin Monocrystalline Silicon Wafer Induced by Dry Polishing

Microdefect Characteristics in Cast‐Mono Silicon Wafers Induced by Slurry Sawing

Study on Subsurface Damage of Wafer Silicon Containing Through Silicon Via in Thinning

A Microscopic Tem Study Of The Defect Layers In Cast-Mono Crystalline Silicon Wafers Induced By Diamond-Wire Sawing

INFLUENCE OF SUB-SURFACE DAMAGE ON TEXTURING OF MONOCRYSTALLINE SILICON WAFERS FOR SOLAR CELLS

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon

Generation and distribution of residual stress during nano-grinding of monocrystalline silicon

Phase Transformation of Monocrystalline Silicon Induced by Polishing With Diamond Abrasives

Effects of grinding speeds on the subsurface damage of single crystal silicon based on molecular dynamics simulations

Study on Material Damage Process of Si under Rotating Disk Test

Surface damage mechanism of monocrystalline silicon during single point diamond grinding

Cutting Speed Dependence of Material Removal Mechanism for Monocrystal Silicon

Analytical prediction for depth of subsurface damage in silicon wafer due to self-rotating grinding process