Abstract:Understanding the initiating and suppression mechanisms of existing defects are the key to optimizing the ultra-precision grinding process of hard and brittle materials. This paper discusses the effects of grinding damage on material removal mechanism from the perspectives of residual scratch depth, scratch morphology and normal scratching force, through conducting the contrast variable-depth nano-scratch experiment on polished and ground monocrystalline silicon and establishing the single grain scratching Smoothed Particle Hydrodynamics (SPH) model. The experimental and simulation results show that radial crack on ground silicon surface is almost invisible due to the existence of grinding marks, which indicates that it is difficult to judge the ductile brittle transition (DBT) point by the traditional method of observing cracks. With the increase of penetration depth, pop-in will occur in the residual scratch depth of polished and ground silicon, indicating that the material removal mode has transformed, which provides an important basis for judging the DBT point. The DBT critical normal scratching force (38.93 mN) and residual scratch depth (−0.14 μm) of ground silicon are much higher than those of polished silicon, implying ground silicon is easier to achieve ductile processing. Meanwhile, when the penetration depth is the same, compared to polished silicon, the normal scratching force of ground silicon is generally larger. Finally, a single grain scratching SPH model of pre-stressed silicon is established. And the simulated phenomenon and conclusions are consistent with the experiment, which proves that the surface compressive stress is an important factor that causes the removal characteristics of ground silicon to be different from polished silicon. This study provides a theoretical basis for understanding the ultra-precision grinding removal mechanism of hard and brittle materials.

Sub-surface Damage of Ultra-Thin Monocrystalline Silicon Wafer Induced by Dry Polishing

Ductile deformation and subsurface damage evolution mechanism of silicon wafer induced by ultra-precision grinding process

Subsurface Damage and Bending Strength Analysis for Ultra-Thin and Flexible Silicon Chips

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon

Microdefect Characteristics in Cast‐Mono Silicon Wafers Induced by Slurry Sawing

Study on Subsurface Damage of Wafer Silicon Containing Through Silicon Via in Thinning

Effects of grinding-induced surface topography on the material removal mechanism of silicon chemical mechanical polishing

Cutting Speed Dependence of Material Removal Mechanism for Monocrystal Silicon

INFLUENCE OF SUB-SURFACE DAMAGE ON TEXTURING OF MONOCRYSTALLINE SILICON WAFERS FOR SOLAR CELLS

A Study on the Surface Quality and Damage Properties of Single-Crystal Silicon Using Different Post-Treatment Processes

Atomistic understanding of the subsurface damage mechanism of silicon (100) during the secondary nano-scratching processing

Phase Transformation of Monocrystalline Silicon Induced by Polishing With Diamond Abrasives

Grinding and lapping induced surface integrity of silicon wafers and its effect on chemical mechanical polishing

Surface Morphology Evolution during Chemical Mechanical Polishing Based on Microscale Material Removal Modeling for Monocrystalline Silicon

Investigation of Material Removal Mechanism of Silicon Wafer in the Chemical Mechanical Polishing Process Using Molecular Dynamics Simulation Method

X-ray Scattering from a Rough Surface and Damaged Layer of Polished Wafers

Towards Investigating Surface Quality of Single-Crystal Silicon Optics Polished with Different Processes

Failure Mechanisms of Cvd Diamond Wafers and Thin Films During Polishing

Subsurface Damage Structure and Eliminating

Surface Evolution and Stability Transition of Silicon Wafer Subjected to Nano-Diamond Grinding