Abstract:Understanding the initiating and suppression mechanisms of existing defects are the key to optimizing the ultra-precision grinding process of hard and brittle materials. This paper discusses the effects of grinding damage on material removal mechanism from the perspectives of residual scratch depth, scratch morphology and normal scratching force, through conducting the contrast variable-depth nano-scratch experiment on polished and ground monocrystalline silicon and establishing the single grain scratching Smoothed Particle Hydrodynamics (SPH) model. The experimental and simulation results show that radial crack on ground silicon surface is almost invisible due to the existence of grinding marks, which indicates that it is difficult to judge the ductile brittle transition (DBT) point by the traditional method of observing cracks. With the increase of penetration depth, pop-in will occur in the residual scratch depth of polished and ground silicon, indicating that the material removal mode has transformed, which provides an important basis for judging the DBT point. The DBT critical normal scratching force (38.93 mN) and residual scratch depth (−0.14 μm) of ground silicon are much higher than those of polished silicon, implying ground silicon is easier to achieve ductile processing. Meanwhile, when the penetration depth is the same, compared to polished silicon, the normal scratching force of ground silicon is generally larger. Finally, a single grain scratching SPH model of pre-stressed silicon is established. And the simulated phenomenon and conclusions are consistent with the experiment, which proves that the surface compressive stress is an important factor that causes the removal characteristics of ground silicon to be different from polished silicon. This study provides a theoretical basis for understanding the ultra-precision grinding removal mechanism of hard and brittle materials.

Microdefect Characteristics in Cast‐Mono Silicon Wafers Induced by Slurry Sawing

A Microscopic Tem Study Of The Defect Layers In Cast-Mono Crystalline Silicon Wafers Induced By Diamond-Wire Sawing

Sub-surface Damage of Ultra-Thin Monocrystalline Silicon Wafer Induced by Dry Polishing

Ductile deformation and subsurface damage evolution mechanism of silicon wafer induced by ultra-precision grinding process

Study on Subsurface Damage of Wafer Silicon Containing Through Silicon Via in Thinning

(Invited) Defects in Cast-Mono Crystalline Silicon

Generation and distribution of residual stress during nano-grinding of monocrystalline silicon

Cutting Speed Dependence of Material Removal Mechanism for Monocrystal Silicon

Subsurface damages beneath fracture pits of reaction-bonded silicon carbide after ultra-precision grinding

An Investigation on the Monocrystalline Silicon Surface Damage Caused by Slurry Erosion

Characteristics of Silicon Substrates Fabricated Using Nanogrinding and Chemo-Mechanical-grinding

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon

Surface Evolution and Stability Transition of Silicon Wafer Subjected to Nano-Diamond Grinding

Multiscale Analyses of Surface Failure Mechanism of Single-Crystal Silicon during Micro-Milling Process

Revealing Silicon Crystal Defects by Conductive Atomic Force Microscope

Influence of Anisotropy on Material Removal and Deformation Mechanism Based on Nanoscratch Tests of Monocrystal Silicon

Study of Prefabricated Crack Propagation on Monocrystalline Silicon Surfaces for Grinding Damage Analysis

Experimental Investigation on the Surface and Subsurface Damages Characteristics and Formation Mechanisms in Ultra-Precision Grinding of SiC

Phase Transformation of Monocrystalline Silicon Induced by Polishing With Diamond Abrasives

Nanoindentation and Deformation Behaviors of Silicon Covered with Amorphous SiO2: a Molecular Dynamic Study

Effects of grinding speeds on the subsurface damage of single crystal silicon based on molecular dynamics simulations