Abstract:The present study reports on experiments and numerical simulations carried out to determine the wear and cutting performance of different polycrystalline diamond (PCD) tools in micro-end milling titanium alloy. The influence of tool geometrical parameters on wear resistance and machined surface precision was discussed. Furthermore, subsurface microstructure alteration was employed as an important index for evaluating the cutting performance of PCD tools. A dislocation dynamics-based multiscale framework, which is capable of promulgating the potential mechanism of above alteration, was adopted to quantitatively predict the evolution behavior of subsurface damages layer during micro-cutting process. The results demonstrated that the tool nose, flank and rake wear were of major wear forms and inappropriate tool structural changes can further accelerate tool failure. A PCD tool with rake angle of 5 degrees, clearance angle of 15 degrees, tool cutting edge radius of 20 mu m and PCD granularity of 10 mu m has highest cutting performance among the tested tools. Using this cutting tool, a surface roughness of Ra = 75 nm better than most previously reported value on titanium alloy Ti-6Al-4V was achieved. A mass of subsurface damages consisted of discrete dislocation configuration, parallel glide lines and persistent slip bands were found after machining. Particularly, small tool cutting edge radius, large rake as well as clearance angle contributed to reducing defects quantity and decreasing the thickness of subsurface damages layer.

Multiscale Analyses of Surface Failure Mechanism of Single-Crystal Silicon during Micro-Milling Process

Research on the Ductile-Mode Machining of Monocrystalline Silicon Using Polycrystalline Diamond (PCD) Tools

Molecular Dynamics Analysis Micro-Mechanism Of Ductile Machining Single Crystal Silicon By Means Of Nanometric Cutting Technology

Investigation of machining mechanism of monocrystalline silicon in nanometric grinding

A Multiscale Simulation Investigation of Dislocation Behaviour of PCD Failure Process

Atomistic investigation of machinability of monocrystalline 3C–SiC in elliptical vibration-assisted diamond cutting

Processing Outcomes of Atomic Force Microscope Tip-Based Nanomilling with Different Trajectories on Single-Crystal Silicon

A Numerical Analysis of Ductile Deformation during Nanocutting of Silicon Carbide via Molecular Dynamics Simulation

Experimental Analysis of Ductile Cutting Regime in Face Milling of Sintered Silicon Carbide

Anisotropy of Single-Crystal Silicon in Nanometric Cutting

Molecular Dynamics Simulation on the Mechanism of Nanometric Machining of Single-Crystal Silicon

Investigations on Brittle-Ductile Cutting Transition and Crack Formation in Diamond Cutting of Mono-Crystalline Silicon

Simulation and experimental investigation on the cutting mechanism and surface generation in machining SiCp/Al MMCs

Micro-milling of Fused Silica Based on Instantaneous Chip Thickness

Effects of microstructures on the material removal mechanisms in nanomachining of polycrystalline materials

Molecular Dynamics Simulation on Cutting Mechanism in the Hybrid Machining Process of Single-Crystal Silicon

Molecular dynamics analysis of subsurface brittleness mechanism of nanocrystalline 3C-SiC rough friction surface

Experimental and Multiscale Numerical Investigation of Wear Mechanism and Cutting Performance of Polycrystalline Diamond Tools in Micro-End Milling of Titanium Alloy Ti-6Al-4V

Experimental Investigation on the Surface and Subsurface Damages Characteristics and Formation Mechanisms in Ultra-Precision Grinding of SiC

Atomistic origin of brittle-to-ductile transition behavior of polycrystalline 3C–SiC in diamond cutting

Effects of grinding speeds on the subsurface damage of single crystal silicon based on molecular dynamics simulations