Abstract:We demonstrate the fabrication of $\sim$1.08 $\mu$m deep microfluidic cavities with characteristic size as large as 7 mm $\times$ 11 mm or 11 mm diameter, using a silicon$-$glass anodic bonding technique that does not require posts to act as separators to define cavity height. Since the phase diagram of $^3$He is significantly altered under confinement, posts might act as pinning centers for phase boundaries. The previous generation of cavities relied on full wafer-bonding which is more prone to failure and requires dicing post-bonding, whereas the these cavities are made by bonding a pre-cut piece of Hoya SD-2 glass to a patterned piece of silicon in which the cavity is defined by etching. Anodic bonding was carried out at 425 $^{\circ}$C with 200 V, and we observe that pressurizing the cavity to failure ($>$ 30 bar pressure) results in glass breaking, rather than the glass-silicon bond separation. In this article, we discuss the detailed fabrication of the cavity, its edges, and details of the junction between the coin silver fill line and the silicon base of the cavity that enables a low internal-friction joint. This feature is important for mass coupling torsional oscillator experimental assays of the superfluid inertial contribution where a high quality factor ($Q$) improves frequency resolution. The surface preparation that yields well-characterized smooth surfaces to eliminate pinning sites, the use of transparent glass as a cover permitting optical access, low temperature capability and attachment of pressure-capable ports for fluid access may be features that are important in other applications.

A new approach to fabricate deep cavities in Pyrex7740 glass for vacuum packaging of sensors

A New Route for Fabricating Polymer Optical Microcavities.

Pyrex Glass Wet Deep Etching and Surface Wiring

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

Fabrication of Via-hole on Pyrex7740 Glass Wafer by HF Wet- Etching Technique

Research on Wafer-Level MEMS Packaging with Through-Glass Vias

Fabrication and Analysis of a Fabry-Perot Cavity with a Micromechanical Wet-Etching Process.

Micro Fabrication of Micro Fluidic Glass Chip Without Clean Room Condition

Fabrication of micro fluidic cavities using Si-to-glass anodic bonding

Novel Method of Fabricating Fabry-Perot Cavity Employing MEMS Wet-Etching Process

Bonding of Glass-Based Microfluidic Chips at Low- or Room-Temperature in Routine Laboratory

Implementation of Silicon-on-glass MEMS Devices with Embedded Through-Wafer Silicon Vias Using the Glass Reflow Process for Wafer-Level Packaging and 3D Chip Integration

Application of PECVD SiC in glass micromachining

Implementation of Various Vacuum Conditions in Sealed Chambers for Wafer-Level Bonding by Using Embedded Cavity

A low temperature, non-aggressive wafer level hermetic package with UV cured SU8 bond

A strategy of wafer-level-plastic-packaging for MEMS based on adhesive bonding

Glass-Based Micro-Hotplate with Low Power Consumption and TGV Structure Through Anodic Bonding and Glass Thermal Reflow

A New Silicon Mold Process for Polydimethylsiloxane Microchannels

0-level Vacuum Packaging RT Process for MEMS Resonators

Fabrication of SiC MEMS Pressure Sensor Based on Novel Vacuum-Sealed Method

Glass Frit Jetting for Advanced Wafer-Level Hermetic Packaging