Abstract:This chapter presents the performance of a two-stage pulse tube cryocooler with 3He as the 2nd stage working fluid. This cooler consists of two pulse tube stages with separate gas supply. To save the amount of 3He, only the smaller second-stage is charged with 3He, while the first stage still operates with 4He as working fluid. A minimum no-load temperature of 1.27 K at the 2nd stage with the 1st stage at 23 K has been achieved by a present two-stage PTC, which is the lowest temperature obtained by regenerative cryocoolers up to now. At an input power of 1.49 kW to the 2nd stage, the cooler provides a maximum cooling power of 735 mW at 4.2 K with 3He. The cooler consists of two parallel separate pulse tube stages. The incoming gas to the second stage is precooled by a heat exchanger thermally connected to the cold end of the first stage. Compared to that of coolers with common gas supply, such design presents higher flexibility in distribution of cooling capacity of the stages and allows an easier adjustment of dc-flow. In addition, this arrangement makes possible to operate the two stages with different compressors and at different operating frequencies.

Performance study of a single-stage pulse tube cooler below 13 K

EXPERIMENTAL RESEARCH OF THERMAL-COUPLED VERSION HIGH FREQUENCY TWO-STAGE PULSE TUBE COOLER

Performance of a pulse tube cryocooler with two separate stages using He-3 in the second stage

Experimental Investigation of Regenerator Matrices on Performance of Pulse Tube Cooler

Performance Study of a Single-Stage Pulse Tube Cooler at 10 K

Performance of a Pulse Tube Cryocooler with Two Separate Stages using 3He in the Second Stage

13 K Thermally Coupled Two-Stage Stirling-Type Pulse Tube Refrigerator

Improvement of a Stirling type two-stage pulse tube cryocooler

A Single-Stage Pulse Tube Cooler Reached 12.6 K

Performance simulation and experiment of regenerator for a high-power single-stage pulse tube cooler

Investigation on High-Performance Single-Stage GM-Type Pulse Tube Cooler

Influence of Input Acoustic Power on Regenerator’s Performance

Thermoacoustically Driven Pulse Tube Cooler below 60K

15 K Two-Stage Stirling-Type Pulse-Tube Cryocooler

Regenerator performance improvement of a single-stage pulse tube cooler reached 11.1 K

Performance study on regenerator of G-M type single stage pulse tube cooler

A single-stage GM-type pulse tube cryocooler operating at 10.6 K

Experiment on a Single-stage GM Type Pulse Tube Cryocooler near 20K

Study on A 5.0 W/80 K Single Stage Stirling Type Pulse Tube Cryocooler

Experimental study on a three-stage cascade pulse tube cryocooler with transmission tube

Therotical and experimental study on a 120 Hz single stage pulse tube cryocooler