Abstract:High strength and high conductivity Cu-based materials are key requirements in high-speed railway and high-field magnet systems. Cu-Fe alloys represent one of the most promising candidates due to the cheapness of Fe compared to Cu-Ag and Cu-Nb alloys. The high strength of Cu-Fe alloys primarily relies on the high density of the Cu/Fe phase interface, which is controlled by the co-deformation of the Cu matrix and Fe phase. In this study, our main attention was focused on the deformation behavior of the Fe phase using different scales. Cu-2.5% Fe-0.2% Cr (in weight) and Cu-6% Fe alloys were cast, annealed, and cold drawn into wires to investigate their microstructure and properties evolution. Cu-6% Fe contains Cu matrix and Fe, which become the primary particles in the micrometer scale after solution treatment. Cu-2.5% Fe-0.2% Cr contains Cu matrix and Fe precipitate particles in a nanometer scale after solution and aging treatment. The Fe primary particles were elongated and evolved into ribbons in a nanometer scale while the Fe precipitate particles were hardly deformed even at a drawing strain of 6. The reason for the unchanging characteristics of Fe precipitate particles is due to the size effect and incoherent phase interface of Cu matrix and Fe precipitate particles. The strength of both Cu-6% Fe and Cu-2.5% Fe-0.2% Cr alloys increases with the increase in the drawing strain. The electrical resistivity of Cu-6% Fe gradually increases and that of Cu-2.5% Fe-0.2% Cr keeps almost constant with the increase in the drawing strain.

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Tensile strength and Young's modulus of Cu-Ag alloys in the evolution of microstructure into filamentary composites

Effects of Drawing Strain on Formation of Filamentary Structure and Conductivity for Cu-12%Ag Alloy

Microstructure evolution and properties of Cu–Ag microcomposites with different Ag content

Evolutions of the microstructure and electrical conductivity of Cu-6wt%Ag alloy during drawing strain

Morphology Evolution of Two-Phase Cu-Ag Alloys under Different Conditions

Relationships between mechanical strength and electrical conductivity for Cu–Ag filamentary microcomposites

EFFECTS OF Ag CONTENT ON MICROSTRUCTURE AND PROPERTIES OF THE FILAMENT STRENGTHENED Cu-Ag ALLOYS

Effects of Cr addition on the microstructural, mechanical and electrical characteristics of Cu–6wt.%Ag microcomposite

Microstructure Evolution of Cu/Ag Interface in the Cu–6 Wt.% Ag Filamentary Nanocomposite

Evolution of microstructure and electrical resistivity of Cu–12wt.%Ag filamentary microcomposite with drawing deformation

Research and Development on Microstructure, Properties and Alloying of Cu-Ag Filamentary Composites

EFFECT OF HEAVILY DRAWING ON THE MICROSTRUCTURE AND PROPERTIES OF Cu-Cr ALLOYS

Microstructure and Hardness of Cu-12% Fe Composite at Different Drawing Strains

Strain Strengthening Of Ag-10cu In Situ Filamentary Composite Prepared By Heavy Deformation

Effects of Drawing Strain on Intensity and Distribution of Crystal Texture in Cu-12%Ag Alloy

Effects of rare-earth additions on the microstructure and strength of Cu–Ag composites

Co-deformation in Cu–6 Wt.% Ag Nanocomposites

The characteristics of Cu–12wt.% Ag filamentary microcomposite in different isothermal process

Microstructure and Properties of Heavily Drawn Cu-Ag-Fe Composites

Microstructure and Properties of Cold Drawing Cu-2.5% Fe-0.2% Cr and Cu-6% Fe Alloys