Abstract:Cu/Al composites have the excellent properties of both Cu and Al, and have the properties of light weight and high conductivity, so they have been widely concerned. In this paper, 5-mm-thick Cu/Al composites prepared by the cast-rolling process are used as experimental materials. To reveal the strengthening and toughening mechanisms of the Cu/Al composites, the interfacial structure, micro-morphology, stress-strain condition, and GND distribution of Cu/Al composites before and after deformation were characterized utilizing TEM, TKD, and EBSD. The results show that the submicron intermetallic compounds Al 2 Cu and Al 4 Cu 9 are formed from the casting-rolling Cu/Al composites. After 15% tensile deformation, many gaps occurred in the interface layer, but at the gaps, there was no crack spreading to the Cu and Al layers. Meanwhile, the deformation in different directions occurs in the Cu grains near the interface, forming a dislocation wall, and the entanglement of the dislocation occurs in the Cu layer near the interface, which contributes to the improvement of tensile strength. The Al layer near the interface layer produces kink bands, which helps to improve the ductility of the composites. Besides, due to the action of the hard intermetallic compound layer, with the increase in tensile deformation, a large number of GND are gradually accumulated in the Cu and Al layers near the interface, resulting in remote back stress, which makes the softer Cu and Al layers obtain higher strength. At the same time, the back stress caused by GND will induce strain hardening, which helps to maintain ductility, so that Cu/Al composites have higher plastic deformation ability while improving mechanical properties.

Strain Strengthening Of Ag-10cu In Situ Filamentary Composite Prepared By Heavy Deformation

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Tensile strength and Young's modulus of Cu-Ag alloys in the evolution of microstructure into filamentary composites

Microstructure evolution and properties of Cu–Ag microcomposites with different Ag content

Relationships between mechanical strength and electrical conductivity for Cu–Ag filamentary microcomposites

Research and Development on Microstructure, Properties and Alloying of Cu-Ag Filamentary Composites

EFFECTS OF Ag CONTENT ON MICROSTRUCTURE AND PROPERTIES OF THE FILAMENT STRENGTHENED Cu-Ag ALLOYS

Co-deformation in Cu–6 Wt.% Ag Nanocomposites

The characteristics of Cu–12wt.% Ag filamentary microcomposite in different isothermal process

Effects of Drawing Strain on Formation of Filamentary Structure and Conductivity for Cu-12%Ag Alloy

Effects of Cr addition on the microstructural, mechanical and electrical characteristics of Cu–6wt.%Ag microcomposite

Microstructure and strength of Cu–Fe–Ag in situ composites

Strength of deformation processed Cu–Fe–Ag in situ composites

Microstructure and Strengthening Model of Cu–Fe In-Situ Composites

Morphology Evolution of Two-Phase Cu-Ag Alloys under Different Conditions

Microstructure Evolution of Cu/Ag Interface in the Cu–6 Wt.% Ag Filamentary Nanocomposite

Microstructure and Properties of Heavily Drawn Cu-Ag-Fe Composites

Properties of Cu and Fe under Large Deformation and Strength Calculation of Cu-11.5% Fe in Situ Composites

Microstructure and Hardness of Cu-12% Fe Composite at Different Drawing Strains

Evolutions of the microstructure and electrical conductivity of Cu-6wt%Ag alloy during drawing strain

Study on strengthening and toughening mechanisms of cu/Al composites dominated by interface layer