Abstract:High strength and high conductivity Cu-based materials are key requirements in high-speed railway and high-field magnet systems. Cu-Fe alloys represent one of the most promising candidates due to the cheapness of Fe compared to Cu-Ag and Cu-Nb alloys. The high strength of Cu-Fe alloys primarily relies on the high density of the Cu/Fe phase interface, which is controlled by the co-deformation of the Cu matrix and Fe phase. In this study, our main attention was focused on the deformation behavior of the Fe phase using different scales. Cu-2.5% Fe-0.2% Cr (in weight) and Cu-6% Fe alloys were cast, annealed, and cold drawn into wires to investigate their microstructure and properties evolution. Cu-6% Fe contains Cu matrix and Fe, which become the primary particles in the micrometer scale after solution treatment. Cu-2.5% Fe-0.2% Cr contains Cu matrix and Fe precipitate particles in a nanometer scale after solution and aging treatment. The Fe primary particles were elongated and evolved into ribbons in a nanometer scale while the Fe precipitate particles were hardly deformed even at a drawing strain of 6. The reason for the unchanging characteristics of Fe precipitate particles is due to the size effect and incoherent phase interface of Cu matrix and Fe precipitate particles. The strength of both Cu-6% Fe and Cu-2.5% Fe-0.2% Cr alloys increases with the increase in the drawing strain. The electrical resistivity of Cu-6% Fe gradually increases and that of Cu-2.5% Fe-0.2% Cr keeps almost constant with the increase in the drawing strain.

Microstructure and Properties of Heavily Drawn Cu-Ag-Fe Composites

Microstructure evolution and properties of Cu–Ag microcomposites with different Ag content

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Attaining Exceptional Electrical Conductivity in Cu-Fe Composite by Powder Rolling Strategy

Relationships between mechanical strength and electrical conductivity for Cu–Ag filamentary microcomposites

Microstructure and Properties of Cu–Fe Microcomposites with Prior Homogenizing Treatments

Tensile strength and Young's modulus of Cu-Ag alloys in the evolution of microstructure into filamentary composites

Research and Development on Microstructure, Properties and Alloying of Cu-Ag Filamentary Composites

Effects of Cr addition on the microstructural, mechanical and electrical characteristics of Cu–6wt.%Ag microcomposite

Microstructure and Properties of Cold Drawing Cu-2.5% Fe-0.2% Cr and Cu-6% Fe Alloys

Microstructure and Properties of Cu-Fe-Ag In-Situ Composites

Microstructure and strength of Cu–Fe–Ag in situ composites

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Microstructure Evolution of Cu/Ag Interface in the Cu–6 Wt.% Ag Filamentary Nanocomposite

EFFECTS OF Ag CONTENT ON MICROSTRUCTURE AND PROPERTIES OF THE FILAMENT STRENGTHENED Cu-Ag ALLOYS

Progress and Current Status in Research on Nanostructured Cu-Ag Microcomposites for Conductor Wires

The characteristics of Cu–12wt.% Ag filamentary microcomposite in different isothermal process

Effects of rare-earth additions on the microstructure and strength of Cu–Ag composites

Effect of annealing processes on microstructure, mechanical properties and conductivity of Cu-12%Ag alloy composite-reinforced by fibers

Evolution of microstructure and electrical resistivity of Cu–12wt.%Ag filamentary microcomposite with drawing deformation

Effects of pre-annealing process on microstructure and properties of the Cu-12%Ag composite wire