Abstract:Bearing shells are widely used in heavy-load friction pairs of high-end machines to reduce wear, thereby extending the lifetime of machines. Tribotests are necessary for bearing shells to evaluate their wear behaviors, reliability, and durability. Existing tribotests of bearing shells can mainly be categorized into two types: full-scale machine tests or local-scale standardized tests (pin-on-disk, etc.). The former has more realistic test configurations but is time/labor-consuming and expensive. Contrarily, the local-scale standardized tests are simple, low-cost, and flexible to use, but their oversimplified contact configurations make the measuring results in poor correlation with practical applications, easily misleading the screen of bearing shells. For that, this study develops a hybrid tribotest method and corresponding instrument (tribometer) to realistically measure the friction and wear of heavy-load bearing shells, which combines the advantages of the facticity of full-scale machine tests with the simplicity and inexpensive of local-scale standardized tests. In this method, a convenient round-arched concave on the bearing shell holder is designed to achieve the conformal contact friction of the bearing shells, of which the size can also be modifiable and compatible with different bearing shells. To reproduce the actual friction conditions in the machine, an easy-to-removal roller counterpart with an adjustable speed down to 0.5 r/min and a hydraulic loading with a controllable force exceeding 93 kN (equivalent to 9.3 ton) are employed to achieve the low speed and heavy load. Based on the method, both alloy- and polymer bearing shells are measured. The measuring results indicate the feasibility of the hybrid measurement method and tribometer. The proposed method offers a facile and actual way for screening structural/material, the wear mechanism analysis, and the contact configuration investigation of bearing shells.

On-chip testing method for measurements of friction and wear in moveable MEMS devices

An on-chip micro-friction tester for tribology research of silicon based MEMS devices

A Single Crystal Silicon Based Micro-tribotester and Testing

A Connected-Type Micro-Tribotester and Its Design

A Micro-Tribotester for Evaluating Friction and Wear on Side Contacting Surfaces in Bulk-Microfabricated Devices

Measurement of static and dynamic friction coefficients of sidewalls of bulk-microfabricated MEMS devices with an on-chip micro-tribotester

Running-In of Sidewall Friction in Bulk-Fabricated Microtribotester

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

Design Of A Composite Microtribology Experiment System For Silicon Sidewalls

Design and Construction of a Micro-Tribotester for Precise In-Situ Wear Measurements

Characterisation Of Tribological Behaviour Of Silicon And Ceramic Coatings Under Repeated Sliding At Micro-Scale

A Novel Running-in Method for Improving Life-Time of Bulk-Fabricated Silicon MEMS Devices

Effect of Surface Energy on the Wear Process of Bulk-Fabricated Mems Devices

An integrated push-to-pull micromechanical device: Design, fabrication, and in-situ experiment

Characterization of the Micro Contact Resistance using a Novel On-Chip Apparatus

Characteristics of the Wear Process of Side-Wall Surfaces in Bulk-Fabricated Si-MEMS Devices in Nitrogen Gas Environment

Hybrid Tribotest Method for Realistically Measuring Friction and Wear of Heavy-Load Bearing Shells

Design and Testing of Micro-Tribometer with Macro Applied Load

Development of the High-speed Sliding-rolling Contact Friction Testing Machine

Friction and wear properties in MEMS

On-Chip Generation Method of Shock Load and Characterization of Microstructure Shock Process