Abstract:The performance and evolution characteristics of the friction interface are crucial for the design optimization of material friction and wear, as well as the revelation of the mechanism of seismic sliding motion. To understand the friction behavior of rough surfaces, it is essential to understand the physical process of interaction among asperities. However, visualizing the contact of asperities is challenging because materials are typically opaque, and the dimensions of asperities are usually in the micron range. This study developed an in-situ scanning electron microscope friction device and a micro speckle fabrication method to measure the strain field of regular asperities from the side, and synchronously measure the macroscopic friction coefficient. In-situ friction experiments were conducted on brass and silicon materials. The results indicate that directly correlating the friction coefficient with the deformation and failure images of asperities can effectively explain the evolution process and differences in friction coefficient for the two materials, validating the performance of the device. Different failure modes of asperities were observed, including severe plastic deformation in brass asperities and fracture-producing large particles in silicon asperities. The critical transition of asperity failure modes in the experiments was analyzed based on a theoretical model. The phase diagram of asperity failure modes and friction coefficient evolution was plotted, providing potential explanation for the evolution of friction coefficient in friction experiments on randomly rough surfaces. The developed device in this study can be used for non-transparent materials and help reveal the microscopic mechanisms behind experimental phenomena.

Design Of A Composite Microtribology Experiment System For Silicon Sidewalls

An on-chip micro-friction tester for tribology research of silicon based MEMS devices

A Micro-Tribotester for Evaluating Friction and Wear on Side Contacting Surfaces in Bulk-Microfabricated Devices

Measurement of static and dynamic friction coefficients of sidewalls of bulk-microfabricated MEMS devices with an on-chip micro-tribotester

A Single Crystal Silicon Based Micro-tribotester and Testing

On-chip testing method for measurements of friction and wear in moveable MEMS devices

Running-In of Sidewall Friction in Bulk-Fabricated Microtribotester

Characterization and Reduction of MEMS Sidewall Friction Using Novel Microtribometer and Localized Lubrication Method

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

Characterisation Of Tribological Behaviour Of Silicon And Ceramic Coatings Under Repeated Sliding At Micro-Scale

Tribological investigation of a low-frequency reciprocating platform

The Contact Behavior Analysis Between Microcomponents on a Low-Frequency Reciprocating-Fretting Ball-on-Flat Tribometer

Design and Construction of a Micro-Tribotester for Precise In-Situ Wear Measurements

Experimental Study of Tribological Properties of Silicon-Based MEMS/NEMS Surface with Atomic Force Microscope

The microtribology and self-lubrication microsystems

In Situ SEM Side Observation of Asperity Behavior During Sliding Contact

Microtribometer Based on a Rotational Grating Displacement Sensing Mechanism

Microtribiology and self-lubrication microsystems

Numerical Simulation and Experimental Investigation on Tribological Performance of SiC Surface with Squamous Groove Micro Texture

Research development of measuring methods on the tribology characters for movable MEMS devices: a review

Study on Controllable Tribological Behaviors of Self-Lubricating Laminated Composites