Abstract:An electromechanically-coupled micro-contact resistance measurement system is built to mimic the contact process during fatigue testing of nanoscale-thickness interconnects using multiple probe methods. The design combines an optical microscope, high-resolution electronic balance, and micromanipulator-controlled electric probe, and is coupled with electrical measurements to investigate microscale contact physics. Experimental measurements are performed to characterize the contact resistance response of the gold nanocrystalline pad of a 35-nm-thick interconnect under mechanical force applied by a tungsten electrode probe. Location of a stable region for the contact resistance and the critical contact force provides better understanding of micro-contact behavior relative to the effects of the contact force and the nature of the contact surface. Increasing contact temperature leads to reduced contact resistance, softens the pad material, and modifies the contact surface. The stability of both contact resistance and interconnect resistance is studied under increasing contact force. Major fluctuations emerge when the contact force is less than the critical contact force, which shows that temporal contact resistance will affect interconnect resistance measurement accuracy, even when using the four-wire method. This performance is demonstrated experimentally by heating the Au line locally with a laser beam. Finally, the contact resistances are calculated using the LET (Li–Etsion–Talke) model together with combined Holm and Sharvin theory under various contact forces. Good agreement between the results is obtained. This research provides a way to measure change in interconnect line resistance directly under a stable contact resistance regime with a two-wire method that will greatly reduce the experimental costs.

Characterization of the Micro Contact Resistance using a Novel On-Chip Apparatus

Characterization of Micro-Contact Properties Using a Novel Micromachined Apparatus

Extraction of micro-contact properties using a novel micromachined on-chip apparatus

Implementation Of Temperature Dependent Contact Resistance Model For The Analysis Of Deep Submicron Devices Under Esd

Characterization of Micro-Contact Resistance Between A Gold Nanocrystalline Line and A Tungsten Electrode Probe in Interconnect Fatigue Testing

Experimental Characterisation and Modelling of On-Chip Capacitors and Resistors on GaAs Substrates

Modeling and Characterization of On‐Chip Interconnects

On-chip testing method for measurements of friction and wear in moveable MEMS devices

Improved Test Fixture for Collecting Microcontact Performance and Reliability Data

A Connected-Type Micro-Tribotester and Its Design

Direct measurements of interfacial contact resistance, end contact resistance, and interfacial contact layer uniformity

Realization of a Test Tool for Diagnosis of Contact Resistance and Measurement of Selected Types of Conductive Materials

A Micro-Tribotester for Evaluating Friction and Wear on Side Contacting Surfaces in Bulk-Microfabricated Devices

An on-chip micro-friction tester for tribology research of silicon based MEMS devices

Parameter characterization of anodic bonded electrical interconnect in MEMS/NEMS devices

Modeling and measurement of contact resistances

J0310203 Development of Non-Contact Measurement of the Electrical Properties of GaAs Wafers

Intermittent Failure Mechanism and Stabilization of Microscale Electrical Contact

Simplified Method of Microcontact Force Measurement by Using Micropressure Sensor

Identifying, quantifying, and mitigating extraneous contact effect in dynamic characterization of flexible devices