Abstract:Contact connections in electrical machines and apparatus are important elements in the whole power supply network and a high level of reliability is expected there. Contact resistance is a fundamental criterion in the design of an electrical contact or contact system. The contact resistance should be as low as possible to minimize losses due to the current passage and the related heating of the contact connection. The value of the contact resistance depends on the material used, the value of the applied force, the type of contact, and, last but not least, the quality of the surface and chemical layers. In this paper, an initial diagnosis of the contact material is performed based on the determination of the sample's specific resistivity by the four-wire method and the evaluation of the measurement uncertainty. The work is followed by the design of a testing device that uses crossed bars to measure the change in contact resistance as a function of the magnitude of the applied force. An analysis of the sample mounting method is performed here using FEM simulations of the current field and shows the interaction between the holder and the sample in terms of current line transfer. The proposed system is then used for experimental measurements of the material-dependent coefficient KC for verification of existing or newly developed materials in electrical engineering, where the values of the KC coefficient are not known. Finally, the paper also deals with the measurement of fritting voltage for individual contact pairs having surface quality corresponding to brushing.

Modeling and measurement of contact resistances

Implementation Of Temperature Dependent Contact Resistance Model For The Analysis Of Deep Submicron Devices Under Esd

Obtaining the specific contact resistance from transmission line model measurements

Research on Parallel Resistance Measurement Principle for Capacitively Coupled Electrical Resistance Tomography

Resistor-to-Schottky barrier analytical model for ohmic contact test structures

Study on the Measurement Accuracy of Circular Transmission Line Model for Low-Resistance Ohmic Contacts on III-V Wide Band-Gap Semiconductors

Hybrid TLM‐CTLM Test Structure for Determining Specific Contact Resistivity of Ohmic Contacts

A Novel Analytical Model for Ohmic Contacts to Planar Devices: Theoretical Design and Experimental Verification

Reeves’s Circular Transmission Line Model and Its Scope of Application to Extract Specific Contact Resistance

Simulation of the contact resistance of high voltage apparatus with the method of coupling contact surface

On Contact Resistance Measurement Using Four-Terminal Kelvin Structures in Advanced Double-Polysilicon Bipolar Transistor Processes

Extraction of Contact Resistivity for a Partial Contact Solar Cell

Standardization of Specific Contact Resistivity Measurements using Transmission Line Model (TLM)

Direct measurements of interfacial contact resistance, end contact resistance, and interfacial contact layer uniformity

Analytical Model for Accurate Extraction of Metal-Semiconductor Ohmic Contact Parameters Using a Novel Electrode-Pair Layout Scheme

Analytical Modeling for Probe Impedance Using Reflection and Transmission Theory in Eddy Current Testing

Semi-analytical Model of the Contact Resistance in Two-Dimensional Semiconductors

Characterization of the Micro Contact Resistance using a Novel On-Chip Apparatus

Realization of a Test Tool for Diagnosis of Contact Resistance and Measurement of Selected Types of Conductive Materials

Modeling and Measurement of A Novel Shielding Design in Silicon Interposer

An LC Resonant Method for the Accurate Extraction of Small Parasitic Resistance