Abstract:This paper presents a generalized model of ohmic contacts and a unified approach for the accurate extraction of specific contact resistivity (ρc) for ohmic contacts from measured contact resistance using the cross bridge Kelvin resistor, the contact end resistor, and the tranmsission line tap resistor test structures. A general three-dimensional (3-D) model of the contacts has been developed from the first principles and has been reduced to 2-D, 1-D, and 0-D (one lump) models with the necessary approximations. It is shown that the conventional I-D models overestimate the value of ρcbecause of the parasitic resistance due to 2-D current flow around the periphery of the contact window. Using 2-D simulations, we have accurately modeled the current crowding effects and have extracted accurate values of ρcindependent of contact size and the test structure type. A theory of scaling of contacts has been developed and is applied to commonly used structures. A universal set of curves has been derived for each particular contact resistance test structure and, given the geometry of the structure, these allow accurate determination of ρc, Without the actual use of the 2-D simulator. Experimental and theoretical accuracy of the three test structures has been compared. Accurate values of ρcfor various contact materials to n+and ρ+Si have been determined. The data confirm that in the past researchers have overestimated ρc, and that ρcwill not limit device performance even with submicrometer design rules.

Reeves’s Circular Transmission Line Model and Its Scope of Application to Extract Specific Contact Resistance

Obtaining the specific contact resistance from transmission line model measurements

Research of Coupling Coefficient Extraction of a Cavity Resonator

Modeling and measurement of contact resistances

Analytical Modeling for Probe Impedance Using Reflection and Transmission Theory in Eddy Current Testing

Standardization of Specific Contact Resistivity Measurements using Transmission Line Model (TLM)

An LC Resonant Method for the Accurate Extraction of Small Parasitic Resistance

Hybrid TLM‐CTLM Test Structure for Determining Specific Contact Resistivity of Ohmic Contacts

Study on the Measurement Accuracy of Circular Transmission Line Model for Low-Resistance Ohmic Contacts on III-V Wide Band-Gap Semiconductors

Simulation of the contact resistance of high voltage apparatus with the method of coupling contact surface

A Novel Analytical Model for Ohmic Contacts to Planar Devices: Theoretical Design and Experimental Verification

The Possible Control Method of Turn-to-Turn Contact Resistivity of REBCO Coil by Surface Coating

Investigation of a Repeatable and Widely Applicable Method to Reduce the Turn-to-turn Contact Resistivity of REBCO Tapes

Theoretical and experimental study of the thermal contact resistance at the junction of crossed cylinders

Turn-to-Turn Contact Resistance Measurement of NI REBCO Double Pancake Coils

Extraction of Contact Resistivity for a Partial Contact Solar Cell

The effects of contact size and non-zero metal resistance on the determination of specific contact resistance

Field and temperature scaling of the critical current density in commercial REBCO coated conductors

Calculation Of The Shrinking Contact Resistance By Truncated Cone Model To Simulate The Contact Of Armature And Rails

Analytical Model for Accurate Extraction of Metal-Semiconductor Ohmic Contact Parameters Using a Novel Electrode-Pair Layout Scheme

A Corrected Method to Extract Dielectric Parameters from Transmission Lines with Conductor Surface Roughness at Terahertz Frequencies