Abstract:Abstract Previous studies of test coils have demonstrated the high thermal and electrical stability of no-insulation (NI) high temperature superconducting (HTS) coils thanks to the presence of turn-to-turn current paths. These turn-to-turn current paths in a NI coil are significantly influenced by the contact resistivity. In practice, it is very challenging to measure the contact resistivity of a NI coil by direct experiments of short samples, since the contact resistivity of superconducting tapes is influenced by surface roughness and tolerance, stress, temperature etc. A proper simulation model is needed to investigate the contact resistivity of the NI coils with dedicated experiments. Hence, in this paper a distributed circuit model is employed. This model, implemented in Matlab 2018a, considers the local contact resistivity, self and mutual inductance, and HTS resistance, which depends on the supplied current, magnetic field and temperature. To validate the model, experimental results from literature, including sudden discharge, and charge–discharge processes, are employed and the results from simulations are consistent with experimental results. Then the model is used to investigate the equivalent contact resistivity of a 157-turn NI coil. Through the comparison of simulated and experimental results, it is found that the contact resistivity of the NI coil has an inhomogeneous distribution. When the current changes with different speeds, ramping rates or frequency, a different number of turn-to-turn contacts carries radial current. Since the turn-to-turn contacts have different contact resistivity, the equivalent contact resistivity calculated from sudden discharge cannot be used in simulations to reproduce all the experimental data.

The Possible Control Method of Turn-to-Turn Contact Resistivity of REBCO Coil by Surface Coating

Investigation of a Repeatable and Widely Applicable Method to Reduce the Turn-to-turn Contact Resistivity of REBCO Tapes

Effect of the Cu Stabilisation Layer on the Turn-to-turn Contact Resistance of a Non-Insulated REBCO Winding

Contact resistivity due to oxide layers between two REBCO tapes

Exploration of Correlation Between the Material Characteristics of the Copper Layer on the Electrical and Thermal Properties of REBCO Tape and Coil

Turn-to-Turn Contact Resistance Measurement of NI REBCO Double Pancake Coils

Experimental study to investigate magnetic field and winding force-dependent contact resistance of NI REBCO coil

Electrical Contact Resistance in REBCO Stacks and Cables With Modified Surfaces

Effects of Wax Impregnation on Contact Resistivity Between REBCO Tapes

Sudden Discharging and Overcurrent Simulations of REBCO Coils Coated With Conductive Epoxy Resin

Experimental study on screening-current induced strain in REBCO insert coils: under critical current control and operation current cycles

Enhanced Normal Zone Propagation Velocity in REBCO Coated Conductors Using an Intermetallic Stabilizer Coating

Residual resistance ratio of Cu stabilizer in commercial REBCO tapes

Database of the effect of stabilizer on the resistivity and thermal conductivity of 20 different commercial REBCO tapes

Synergic realization of electrical insulation and mechanical strength in liquid nitrogen for high-temperature superconducting tapes with ultra-thin acrylic resin coating

Delamination Avoidance in Epoxy Wet-Wound REBCO Coils by Release Agent Coating

Effect of the SS304 Coating Layer on the Electrical and Thermal Properties of REBCO Commercial Tape

Study of contact resistivity of a no-insulation superconducting coil

In Situ Detection of Delamination and Critical Current Degradation Caused by the Thermal Stress in Epoxy Impregnated REBa2Cu3O7−δ Coils

An Advanced Computational Approach for Evaluating Screening-Current-Induced Strain in REBCO HTS Coils Considering Electromagnetic-Mechanical Coupling

Reduction in AC Loss of REBCO Coils with Optimum Multi-Width Tape Induced by Part Slitting Method