Electrical Contact Resistance in REBCO Stacks and Cables With Modified Surfaces

Shengchen Xue,Mike D. Sumption,Dean Panik,Chee J. Thong,Xiaolei Guo,Milan Majoros,Edward W. Collings

DOI: https://doi.org/10.1109/tasc.2022.3165736

IF: 1.9489

2022-09-01

IEEE Transactions on Applied Superconductivity

Abstract:Rare-earth barium copper oxide (REBCO) coated conductors are of interest for fabricating high performance cables and magnets for magnetic field B > 22.5 T. One critical challenge is the control of the current sharing between conductor tapes to enable self-protection to take place when a localized disturbance (hot spot) appears in the cable or magnet coil. Current sharing can be enhanced by reducing the inter-strand contact resistance (ICR). In this work, we explore ICR reduction with several tape surface modification techniques. Under a pressure of 13.3 MPa the contact efficiency, int of a ten-layer REBCO tape stack was measured to be 106 $mu$cm2 at 4.2 K and 145 cm2 at 77 K. Further increases in pressure had only a small effect on ICR. To further reduce ICR, we proposed two other techniques: (1) Heat treatment of the ten-layer YBCO coated conductor tape stack at 300 C for 30 min and under various pressures. We concluded that 20 MPa was the minimum pressure required to initiate substantial conductor-to-conductor sintering and an optimum result was achieved by a processing pressure higher than 23.4 MPa which produced int of 10 cm2 at 4.2 K and 19 cm2 at 77 K when measured under 13.3 MPa. (2) The second approach was to Ni-plate the REBCO tapes. The acidic plating solution removes the native oxide on the Cu surface and the process replaces it with a thin layer of Ni. The result was an int of 2.7 cm2 at 4.2 K and 4.6 cm2 at 77 K. Both techniques led to int that were relatively insensitive to changes in temperature. We were able to achieve int < 10 cm2 with sintering under pressure, and int < 3 cm2 with Ni electroplating alone.

physics, applied,engineering, electrical & electronic