Abstract:REBCO high-temperature superconductor has been widely used in high magnetic field applications, because of the excellent critical current properties and high critical temperature. However, REBCO tape has an extremely large width-to-thickness ratio (typically in the range of 1000-10000) to cause too high power dissipation in the applications. One of the effective ways to reduce AC loss is to divide the superconducting layer in the REBCO tape into filaments. The current-carrying properties degradation behavior of the prepared multi-filamentary tape is the focus of attention. In this study, REBCO multi-filamentary tapes with different numbers of filaments (2-filament, 6-filament, and 10-filament) by cutting the copper-stabilizing layers and superconducting layers through a self-developed reel-to-reel ultraviolet picosecond laser cutting device. The findings indicate that the cut groove has a depth of approximately 30 μm and the width of the groove on the superconducting layer measures around 15 μm. Meanwhile, the researchers found that ultraviolet picosecond laser cutting does not cause substantial degradation in the IC. Under self-field conditions at 77 K, the IC decreases with the number of filaments, and the degradation of IC is less than 13% in a 10-filament tape, the corresponding decrease of JC is only about 10%. Similarly, at 4.2 K and under various high-field (10 T, 12 T, 14 T) conditions, the IC variation trends of REBCO HTS multi-filamentary tapes and non-striated tapes are fundamentally similar, both decreasing as the applied vertical magnetic field increases. Furthermore, it was found that a constant tension of 50 MPa, 100 MPa, and 200 MPa had no effect on the current-carrying properties of the REBCO HTS multi-filamentary tapes.

Critical current degradation and delamination crack observation of epoxy-coated REBCO superconducting tapes after thermal cycles in liquid nitrogen

In Situ Detection of Delamination and Critical Current Degradation Caused by the Thermal Stress in Epoxy Impregnated REBa2Cu3O7−δ Coils

Delamination Avoidance in Epoxy Wet-Wound REBCO Coils by Release Agent Coating

Critical Current Degradation Behaviour of Various REBCO Tapes under Uniaxial Strain

Electromechanical degradation of REBCO coated conductor tapes under combined tension and torsion loading

Evaluation of the effect of edge cracks on critical current degradation in REBCO tapes under tensile stress

Interface Properties and Failures of REBCO Coated Conductor Tapes: Research Progress and Challenges

Bending-Peeling Method to Research the Effect of Lateral Stress on Superconductivity of REBCO Tape at Liquid-Nitrogen Temperature

Critical current degradation of commercial REBCO coated conductors under thermomechanical loads

Synergic realization of electrical insulation and mechanical strength in liquid nitrogen for high-temperature superconducting tapes with ultra-thin acrylic resin coating

Influence of Edge Crack Propagation on Critical Current Degradation of REBCO Tape Studied by Phase-Field Fracture Method and Current Shunting Model

Critical Current Degradation in an Epoxy-Impregnated Rare-Earth Ba2Cu3O7−x Coated Conductor Caused by Damage During a Quench

Synergetic Evolution of the Microscopic Crystal Orientation and Macroscopic Superconducting Properties of REBCO Tape under Sever Deformation

Fatigue Behavior of Critical Current Degradation for YBCO Tapes at 77 K

Current-carrying properties of REBCO multi-filamentary tapes prepared by reel-to-reel ultraviolet picosecond laser cutting

Monitoring fatigue failure in REBCO coated conductors at cryogenic temperatures using advanced optical fiber sensors

Delamination Properties of YBCO Tapes Under Shear Stress Along the Width Direction

Novel Two-Step Procedure for Measuring I C Vs. Tensile Stress of Commercial REBCO Tape

Critical Current Degradation of YBCO Tape with Different Stabilizing Layers under Cyclic Mechanical Strains

Experimental Study on Cabling Properties of Different REBCO Coated Tapes

Electromechanical Characteristic of Stacked REBCO Tapes under Tension Deformation