Abstract:REBCO coated conductors are now being used for building very high-field magnets with large electromagnetic stresses, both expected ones due to transport current × stresses and additional stresses resulting from the large screening currents inherent in wide tapes. Post mortem analyses of several recent test coils operated above 40 T show that significant conductor plastic deformation occurs, even for JBR stresses well below the ~1 GPa yield of the Hastelloy substrate of the conductor. To investigate these deformation mechanisms, conductors were unwound after coil test and carefully examined with respect to their length-wise Ic which revealed many areas of local damage. Regions of interest were examined by metallographic cross-section, Hall microscopy, magneto-optic imaging and scanning electronic microscopy. Important damage frequently occurred to the outer edges of pancakes in the coil ends, which were often plastically deformed over the whole turn circumference, especially when this outer edge was a slit edge. Internal conductor damage was also seen, especially delamination between the buffer and REBCO layers at slit edges. Careful sectioning of the tape at ~10 mm intervals showed that the plastic deformation of the turns was complex and variable around the turn circumference, with tape cross-sections that exhibited continuous shape change in the outer turns. The bending center line of tapes often shifted from the tape center line toward the edge closest to the coil center, indicating asymmetric effects of transport and screening current stresses across the conductor width. A surprising and vital result is that damage was prevalent when the slit edge was also the edge at which transport current flowed. This damage was absent when the transport current flowed at the not-slit edge, implying great sensitivity of the effect of screening current stresses to localized conductor damage.

REBCO delamination characterization by 90 degree peel test

Delamination Avoidance in Epoxy Wet-Wound REBCO Coils by Release Agent Coating

Bending-Peeling Method to Research the Effect of Lateral Stress on Superconductivity of REBCO Tape at Liquid-Nitrogen Temperature

Study of delamination in REBCO coated conductor by transmission electron microscopy

In Situ Detection of Delamination and Critical Current Degradation Caused by the Thermal Stress in Epoxy Impregnated REBa2Cu3O7−δ Coils

Performance study of REBCO multi-filament tapes/ CORC cables prepared by reel-to-reel mechanical incision

Critical Current Degradation Behaviour of Various REBCO Tapes under Uniaxial Strain

Experimental Study on Cabling Properties of Different REBCO Coated Tapes

Exploration of Correlation Between the Material Characteristics of the Copper Layer on the Electrical and Thermal Properties of REBCO Tape and Coil

Residual resistance ratio of Cu stabilizer in commercial REBCO tapes

Critical current degradation and delamination crack observation of epoxy-coated REBCO superconducting tapes after thermal cycles in liquid nitrogen

REBCO tapes for applications in ultra-high fields: critical current surface and scaling relations

Novel Two-Step Procedure for Measuring I C Vs. Tensile Stress of Commercial REBCO Tape

Vortex Shaking Study of REBCO Tape with Consideration of Anisotropic Characteristics.

Plastic Deformation Simulation of REBCO Tapes Using Particle Methods

Contact resistivity due to oxide layers between two REBCO tapes

The Study of Epoxy-Impregnated REBCO Coils

High-field thermal transport properties of REBCO coated conductors

Current-carrying properties of REBCO multi-filamentary tapes prepared by reel-to-reel ultraviolet picosecond laser cutting

Thermal conductivity of REBCO tapes with different stabilizers from 4.2 to 200 K

Analyses of the plastic deformation of coated conductors deconstructed from ultra-high field test coils