Abstract:Struts of a superconducting YBa2Cu3Oy (YBCO) foam prepared by the infiltration growth method on the base of commercial polyurethane foams were extracted from the bulk, and thoroughly characterized concerning the microstructure and the magnetoresistance, measured by the four-point technique. Optical microscopy, electron microscopy, electron backscatter diffraction and atomic force microscopy observations indicate a unique microstructure of the foam struts which shows a large amount of tiny Y2BaCuO5 (Y-211) particles (with diameters between 50 and 100 nm) being enclosed in channel-like grain boundaries between the YBCO grains and a one-of-a-kind surface of the struts covered with Ba3Cu5Oy-particles. The resistance data obtained at temperatures in the range 4.2 K ≤T≤ 150 K (applied magnetic fields ranging from 0 to 7 T) were analyzed in the framework of the fluctuation-induced conductivity (FIC) approach using the models of Aslamazov–Larkin (AL) and Lawrence–Doniach (LD). The resulting FIC curves reveal the presence of five distinct fluctuation regimes, namely, the short-wave (SWF), one-dimensional (1D), two-dimensional (2D), three-dimensional (3D), and critical (CR) fluctuation domains. The analysis of the FIC data enable the coherence length in the direction of the c-axis at zero-temperature (ξc(0)), the irreversibility field (Birr), the upper critical magnetic field (Bc2), the critical current density at T= 0 K (Jc(0)) and several other parameters describing the the material's superconducting properties to be determined. The present data reveal that the minuscule Y-211 particles found along the YBCO grain boundaries alter the excess conductivity and the fluctuation behavior as compared to conventional YBCO samples, leading to a quite high value for Jc(0) for a sample with a non-optimized pinning landscape.

Critical Current Survival in the YBCO Superconducting Layer of a Delaminated Coated Conductor

Delamination Properties of YBCO Tapes Under Shear Stress Along the Width Direction

Delamination Strength of the Soldered Joint in YBCO Coated Conductors and Its Enhancement

A standardized measurement method and data analysis for the delamination strengths of YBCO coated conductors

Preparation and Critical-Current Measurements of Laser-Ablated Ybco Superconducting Thin-Films

Fabrication and Analysis of Tri-layer YBa 2 Cu 3 O 7− δ Thick Films by Low-Fluorine MOD Method

Fabrication and Analysis of Tri-layer YBaCu Thick Films by Low-Fluorine MOD Method

Fabrication And Analysis Of Tri-Layer Yba2cu3 O (7-Delta) Thick Films By Low-Fluorine Mod Method

Improvement of Surface Morphology and Superconducting Properties of YBCO Coated Conductor on Ni-W Tapes

Critical current degradation and delamination crack observation of epoxy-coated REBCO superconducting tapes after thermal cycles in liquid nitrogen

YBCO Superconducting Thin Film Preparation on Metallic Substrates by Laser

Thick $\Hbox{yba}_{2}\hbox{cu}_{3}\hbox{o}_{7-\Delta}$ Superconducting Films by Low-Fluorine Metallorganic Solution Deposition

Dependence of Microstructure and J C of YBCO Films on CeO 2 Cap Layers Deposited by Multi-plume PLD

Surface characterization of as-grown CeO2 cap layer morphology evolution and critical current density of post-deposited YBCO films

Improved Superconducting Performance of YBCO-Coated Conductors by Low Energy Density Argon Ion Etching

Influence of Buffer Layer Surface Morphology on YBCO Critical Current Density Deposited on NiW Tapes

Hydrostatic Pressure Effects on the Critical Current of YBCO Coated Conductor Wire

The strain effect on critical current in YBCO coated conductors with different stabilizing layers

Excess Conductivity Analysis of an YBCO Foam Strut and Its Microstructure

Low-cost YBCO coated conductor technology

Experimental and Numerical Study of Frequency-Dependent Transport Loss in YBa2Cu3O7–δ Coated Conductors with Ferromagnetic Substrate and Copper Stabilizer