Abstract:An electromechanically-coupled micro-contact resistance measurement system is built to mimic the contact process during fatigue testing of nanoscale-thickness interconnects using multiple probe methods. The design combines an optical microscope, high-resolution electronic balance, and micromanipulator-controlled electric probe, and is coupled with electrical measurements to investigate microscale contact physics. Experimental measurements are performed to characterize the contact resistance response of the gold nanocrystalline pad of a 35-nm-thick interconnect under mechanical force applied by a tungsten electrode probe. Location of a stable region for the contact resistance and the critical contact force provides better understanding of micro-contact behavior relative to the effects of the contact force and the nature of the contact surface. Increasing contact temperature leads to reduced contact resistance, softens the pad material, and modifies the contact surface. The stability of both contact resistance and interconnect resistance is studied under increasing contact force. Major fluctuations emerge when the contact force is less than the critical contact force, which shows that temporal contact resistance will affect interconnect resistance measurement accuracy, even when using the four-wire method. This performance is demonstrated experimentally by heating the Au line locally with a laser beam. Finally, the contact resistances are calculated using the LET (Li–Etsion–Talke) model together with combined Holm and Sharvin theory under various contact forces. Good agreement between the results is obtained. This research provides a way to measure change in interconnect line resistance directly under a stable contact resistance regime with a two-wire method that will greatly reduce the experimental costs.

A Connected-Type Micro-Tribotester and Its Design

A Micro-Tribotester for Evaluating Friction and Wear on Side Contacting Surfaces in Bulk-Microfabricated Devices

A Single Crystal Silicon Based Micro-tribotester and Testing

On-chip testing method for measurements of friction and wear in moveable MEMS devices

An on-chip micro-friction tester for tribology research of silicon based MEMS devices

Measurement of static and dynamic friction coefficients of sidewalls of bulk-microfabricated MEMS devices with an on-chip micro-tribotester

Design Of A Composite Microtribology Experiment System For Silicon Sidewalls

Running-In of Sidewall Friction in Bulk-Fabricated Microtribotester

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

Design and Construction of a Micro-Tribotester for Precise In-Situ Wear Measurements

Design and Testing of Micro-Tribometer with Macro Applied Load

Characterisation Of Tribological Behaviour Of Silicon And Ceramic Coatings Under Repeated Sliding At Micro-Scale

Characterization of the Micro Contact Resistance using a Novel On-Chip Apparatus

An integrated push-to-pull micromechanical device: Design, fabrication, and in-situ experiment

Characterization of Micro-Contact Properties Using a Novel Micromachined Apparatus

APPLICATION OF SUPER-MICRO TESTER IN MEMS BONDING STRENGTH TEST

Characterization of Micro-Contact Resistance Between A Gold Nanocrystalline Line and A Tungsten Electrode Probe in Interconnect Fatigue Testing

A New Test Structure To Measure Bonding Strength In Micro-Bonding Area

Monotonic and fatigue testing of spring-bridged freestanding microbeams application for MEMS

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Measurement of Slips at Contact Interfaces Using a Self-Powered Sensor Based on Triboelectric Nanogenerators