Abstract:A novel micro-electromechanical systems inertial switch based on non-silicon surface micromachining technology has been designed, fabricated and characterized in the present work. Compared with the traditional inertial switch, a compliant cantilever beam as a stationary electrode has been proposed to prolong the contact time, which can realize sufficient elastic deformation during the contact between the electrodes. The dynamic contact process is analyzed theoretically and the corresponding mechanical impact mechanism is also explained. To investigate the contact-enhancing mechanism of the cantilever beam, the switch applied half-sine acceleration with various amplitudes in the sensitive direction is simulated with ANSYS software. The dynamic simulation results confirm the contact-enhancing mechanism described by the theoretical analysis and it is shown that the contact time (i.e., the switch-on time) can be prolonged effectively by utilizing the elastic deformation of the cantilever beam and increased with the applied accelerations. The inertial switch is successfully fabricated by electroplating and sacrificial layer processes technologies. The prototype has been characterized by dropping hammer experiment. The test results indicate that the contact effect is improved significantly and the contact time is ∼80 µs under the 297 g acceleration, and the maximum value is ∼410 µs for the 672 g acceleration amplitude, which is in general accordance with the simulated results. The mechanical contact between the cantilever beam and the proof mass is evaluated following thousands of impacts. The scanning electron micrographs of the contact surfaces indicate that the all-metal switch still keeps a good mechanical property after suffering the hot contact, and the contact resistance is also stable.

The mechanical behavior investigation of MEMS switches for millimeter wave phase shifters

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Intermodulation Distortion in MEMS Capacitive Switches under High RF Power

A laterally-driven micromachined inertial switch with a compliant cantilever beam as the stationary electrode for prolonging contact time

Design, simulation, and testing of a tunable MEMS multi-threshold inertial switch

Power Handling Capability Enhanced RF MEMS Switch Using Modified-Width Cantilevers Structure

Mechanical Model of Low Actuation Voltage RF MEMS Switches

DC-contact Series Radio-Frequency Micro Electromechanical System Switch with Slanting Beams

Numerical Analysis of Pull-In Voltage for Contact Mems Switches in Switched-Line Phase Shifter Application

Novel Multicontact Radio Frequency Microelectromechanical System Switch in High-Power–handling Applications

Design and Analysis of a Lateral Lateral DC-Contact MEMS RF Switch with High Performance

Low-voltage Micromachining-Based Scalable Optical Switch

A 0.2 V Micro-Electromechanical Switch Enabled by a Phase Transition

A Planar Single-Actuator Bi-Stable Mechanical/Electrical Switch

Electro-thermally actuated RF MEMS switch for wireless communication.

Design of A Novel Bulk Micro-Machined Rf Mems Switch

Design and fabrication of X-band capacitive MEMS switches

Symmetrical Design And Analysis Of A Novel Mems-Based 1x2 Optical Switch

Capacitive Rf MEMS Switch with Composite Beam

High-Isolation Contact Switch in Mems Phase Shifter

Novel Process for Fabrication of RF MEMS Switch with High Mechanical Reliability