Abstract:Titanium silicide (TiSi2) thin films were prepared on glass substrate by atmospheric pressure chemical vapor deposition using SiH4 and TiCl4 as the precursors. The phase structure of the thin films was identified by x-ray diffractometry. The surface morphology and thickness of the thin films were observed by field emission scannig electron microscopy and the sheet resistance of the thin films was measured using the four point probe method. The results show that the TiSi2 thin films are formed in a face-centered orthorhombic structure. Due to the influence of the amorphous glass substrate, an amorphous layer is initially formed on the substrate and the TiSi2 crystalline phase grows on top of it. As the thickness and content of TiSi2 crystalline phase increase with deposition time, the resistivity of the thin film decreases. Besides, the growth rate and thus the size of TiSi2 crystalline phase increase as the deposition temperature increases. The stack density decreases when the deposition temperature increases above 700°C because the rapid growth at the higher temperatures causes more irregular shape of crystalline particles. The maximal stack density of the crystalline phase and thus the minimum resistivity of the thin films are obtained at the deposition temperature of 700°C. The expressions of the stack density of crystalline phase and the resistivity of the thin films as functions of the deposition conditions are theoretically deduced which are well consistent with the experimental results.

Atmospheric Pressure Chemical Vapor Deposition of TiSi2 Films on Glass

Nucleation and Growth of Tisi2 Thin Films Deposited on Glass by Atmospheric Pressure Chemical Vapor Deposition

Preparation and Properties of Titanium Silicide Coating Glass by CVD

EFFECT OF CRYSTALLINE PHASE FORMATION ON OPTICAL PROPERTIES OF TiSi2 THIN FILMS

Structure and hydrophilicity of titanium dioxide film prepared by atmospheric pressure chemical vapor deposition

Microporous Textured Titanium Dioxide Films Deposited at Atmospheric Pressure Using Dielectric Barrier Discharge Assisted Chemical Vapor Deposition

Influence of substrates on the formation of the TiSi nanowire by atmosphere pressure chemical vapor deposition.

Fabrication of Titanium Dioxide Thin Films by DBD-CVD under Atmosphere

APPLICATION AND OPTICAL PROPERTIES OF TiO_2 THINFILMS PREPARED BY CHEMICAL VAPOUR DEPOSITION

Microstructure and oxidation behavior of SiOC coatings on C/C composites co-deposited with HMDS and TEOS by using CVD process

The Structure and Properties of V Doped TiN Films Prepared at Various Temperatures

Electrical and Corrosion Properties of the Ti5Si3 Thin Films Coated on Glass Substrate by APCVD Method

Electrical and optical properties of titanium nitride coatings prepared by atmospheric pressure chemical vapor deposition

Microstructures and Properties of N-Doped TiO_2 Films Grown by Atmospheric Pressure Chemical Vapor Deposition

Fast coating of TiO2 on glass by chemical vapor deposition at atmospheric pressure

Preparation of titanium silicide nanowires by APCVD method

Study of Titanium Nitride for Low-E Coating Application

Influence of the partial pressure of ethene on the crystallinity of 3C-SiC films grown on Si(111) by chemical vapor deposition

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

Effects of the Deposition Temperature on the Structure and Solar Control Performance of Tin Coatings Prepared by Apcvd

Compositional dependence of epitaxial Tin+1SiCn MAX-phase thin films grown from a Ti3SiC2 compound target