Abstract:In this investigation, a novel heat-sensitive material titanium oxide (TiOx) thin film was deposited on well cleaned K9 glass substrates by d.c. reactive magnetron sputtering from a metallic titanium target in an Ar + O2 gas mixture. In order to obtain proper TiOx thin films, deposition parameters should be properly controlled. In our system, TiOx thin films were obtained at different substrate temperature while total pressure and oxygen partial pressure were kept at 1 Pa and 0.6 Pa, d.c. power of 100 W, and the deposition time was adjusted in order to deposit thin films with a constant thickness close to 200 nm. The crystalline structure was characterized by X-ray diffraction (XRD) analysis and the results show that all the deposited films have an amorphous structure. In this paper, we have mainly investigated the dependence of electrical and optical properties of the reactively sputtered TiOx thin films on the different substrate temperature during the sputtering process, i.e., as the K9 glass substrate temperature increases from 100 °C to 250°C, the sheet resistance Rs of TiOx thin films is ranged from 305 kΩ/square to 36 kΩ/square, temperature coefficient of resistance (TCR) value up to -2.12 %/K is obtained, optical band gap decreases from 3.34 eV to 3.28 eV. Through the analysis and discussion of the above experimental data, we could obtain the conclusion that the variation in substrate temperature during the sputtering deposition plays a considerable important role in the electrical and optical properties of all the deposited films.

Electrical and Corrosion Properties of the Ti5Si3 Thin Films Coated on Glass Substrate by APCVD Method

APPLICATION AND OPTICAL PROPERTIES OF TiO_2 THINFILMS PREPARED BY CHEMICAL VAPOUR DEPOSITION

Electrical and optical properties of titanium nitride coatings prepared by atmospheric pressure chemical vapor deposition

Atmospheric Pressure Chemical Vapor Deposition of TiSi2 Films on Glass

Study of Titanium Nitride for Low-E Coating Application

Effects of the Deposition Temperature on the Structure and Solar Control Performance of Tin Coatings Prepared by Apcvd

Corrosion characteristics of Ti and Al2O3/Ti thin films sputtered on 316LSS

APCVD Prepared TiNxOy Films with Energy-Saving and Self-Cleaning Functions

Preparation and Properties of Titanium Silicide Coating Glass by CVD

Nucleation and Growth of Tisi2 Thin Films Deposited on Glass by Atmospheric Pressure Chemical Vapor Deposition

Electrochemical corrosion of Ti-Si-N films coated by pulsed-DC plasma enhanced CVD

Corrosion Resistance of Ti-Pd Coating Prepared on Titanium Substrate by Glow Plasma Surface Metallurgy Process

Characterization of Corrosion Products on TiSi, TiAl, and WTi Coatings

Thermally Induced Microstructure Evolution and Effects on the Corrosion Behaviors of AlFeSi Metallic Glass Coatings

Improving the Anticorrosion and Mechanical Behaviour of PACVD TiN

Effect of Substrate Type on the Electrical and Structural Properties of TiO2 Thin Films Deposited by Reactive DC Sputtering

Deposition voltages on the phase evolutions, microstructures, and oxidation behaviors of thermal-resistance Glass-MoSi2-SiC coating

The Influence of Substrate Temperature on the Electrical and Optical Properties of Titanium Oxide Thin Films Prepared by D.c. Reactive Magnetron Sputtering

Preparation of TiSi Nanowires by APCVD Used for Improving Dielectric Properties of PST Thin Film

Electrochemical Corrosion Behavior of Plasma Sprayed Al2o3-13%Tio2 Coatings in Aqueous Hydrochloric Acid Solution

EFFECT OF CRYSTALLINE PHASE FORMATION ON OPTICAL PROPERTIES OF TiSi2 THIN FILMS