Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

Six-parameter Model Study of Ash Formation Characteristics of Coals in a Circulating Fluidized Bed Boiler

A six-parameter model to predict ash formation in a CFB boiler

A general mechanistic model of fly ash formation during pulverized coal combustion

Semi-empirical Technique for Predicting Ash Size Distribution in CFB Boilers

Experiments on Ash Formation of Different Coals in Circulating Fluidized Bed Combustion

Model Research On Material Balance In A Circulating Fluidized Bed Boiler

Ash Formation Characteristics of Two Indonesian Coals and the Change of Ash Properties with Particle Size

Experimental Investigation On Three Coals Ash Formation

Model of coal slime combustion behavior in CFB boiler

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

EXPERIMENTAL TECHNIQUE ON COAL ASH FORMATION IN CFB COMBUSTION

Modeling of Single Coal Particle Combustion in O2/N2 and O2/CO2 Atmospheres under Fluidized Bed Condition

Ash Fouling Monitoring Dynamic Models of Coal-Fired Utility Boiler's Heat Transfer Surface

Modeling Study of Combustion Process of Oil Shale Semicoke in a Circulating Fluidized Bed Boiler

A Numerical Study of Ash Deposition Characteristics in a 660MW Supercritical Tangential Boiler

Ash Fouling Monitoring and Key Variables Analysis for Coal Fired Power Plant Boiler

Heat-Transfer Model of the Rotary Ash Cooler Used in Circulating Fluidized-Bed Boilers

Modeling the Process and Properties of Ash Formation during Pulverized Biomass Combustion

Fine Particulate Formation And Ash Deposit Behavior During Sawdust/Coal Co-Firing

EXPERIMENTAL STUDY OF ASH DEPOSIT DURING CO-FIRING SAWDUST AND COAL

Numerical Simulation of Ash Deposit of Typical Coal in Pulverized Coal-Fired Boiler