Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

Model Research On Material Balance In A Circulating Fluidized Bed Boiler

1D modeling on the material balance in CFB boiler

The Study of Unified Thermal Calculation Model of Circulating Fluidized Bed Boiler Based on Experience

Calculation method for the dynamic total mass balance of CFBC

Mass Balance Performance Of A 300mw Cfb Boiler Burning Blend Fuel With Different Mixing Ratio

Particle Population Balance Model for a Circulating Fluidized Bed Boiler

Study on the dynamic balance behaviors of bed material during the start-up process of a circulating fluidized bed boiler

A six-parameter model to predict ash formation in a CFB boiler

General dynamic mathematical model for the total mass balance of CFBC

Modeling of a 300 MW Circulating Fluidized Bed Boiler

Model Prediction of the Operating Behavior of a Circulating Fluidized Bed Boiler

Semi-empirical Technique for Predicting Ash Size Distribution in CFB Boilers

An experimental and simulation investigation into the energy balance and material balance characteristics in a fluidized bed heat exchanger

Numerical Simulation of the Bed Material Unbalance Between the Breeches-legs in a Circulating Fluidized Bed Boiler

A Comprehensive Mass Balance Model of a 550 MWe Ultra-Supercritical CFB Boiler with Internal Circulation

Modeling of Circulating Fluidized Bed Boiler Performance

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

Modeling Study on Non‐Uniform Lateral Distribution in Large‐Scale Circulating Fluidized Bed Boilers

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

12th International Conference on Fluidized Bed Technology MODELING STUDY ON NON-UNIFORM DISTRIBUTION IN THE LATERAL DIRECTION IN LARGE SCALE CFB BOILERS

CFD modeling of sodium transformation during high-alkali coal combustion in a large-scale circulating fluidized bed boiler