Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

The Study of Unified Thermal Calculation Model of Circulating Fluidized Bed Boiler Based on Experience

Simulating growth of ash deposit in boiler heat exchanger tube based on CFD dynamic mesh technique

Dynamic CFD modeling and evaluation of ash deposition behaviors during Zhundong coal combustion

Advanced Modeling Approaches for CFD Simulations of Coal Combustion and Gasification

Simulation of Ash Deposition in Different Furnace Temperature with a 2D Dynamic Mesh Model

STUDY ON PREDICTION MODEL FOR TEMPERATURE OF FLUE GAS EXHAUSTED FROM UTILITY BOILERS BASED ON PROPERTIES OF FUEL COAL

Modelling of Fly Ash Viscous Deposition and Slagging Prediction of Biomass-fired Boiler

Simulation of Ash Deposit in A Pulverized Coal-Fired Boiler

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

A six-parameter model to predict ash formation in a CFB boiler

Numerical simulation and mathematical models of ash deposition behavior considering particle properties and operating conditions

Prediction of ash deposition in ash hopper when tilting burners are used

Combustion Modeling Of Cfb Boiler Furnace Based On An Euler-Euler Approach

Research of Heat Transfer Model in Rotary Ash Coolers

Numerical Simulation of Fly Ash Deposition in Coal and Corn Stalk Co-Combustion with Dynamic Mesh Technique

Understanding the Ash Deposition Formation in Zhundong Lignite Combustion Through Dynamic CFD Modelling Analysis

Heat-Transfer Model of the Rotary Ash Cooler Used in Circulating Fluidized-Bed Boilers

Soot Formation and Its Radiative Heat Transfer in Coal Flames: Model Development and Implementation With FLUENT

Model Prediction of the Operating Behavior of a Circulating Fluidized Bed Boiler