Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

Heat-Transfer Model of the Rotary Ash Cooler Used in Circulating Fluidized-Bed Boilers

The Study of Unified Thermal Calculation Model of Circulating Fluidized Bed Boiler Based on Experience

Research of Heat Transfer Model in Rotary Ash Coolers

Heat Transfer in the Rotary Ash Cooler with Residual Char Combustion Considered

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Experimental Study on Heat Transfer in Rolling Ash Cooler

Design and Operation of the Double-Cylinder Rotary Ash Cooler for Large CFB Boilers

Heat Transfer Coefficient Calculation of a Circulating Fluidized Bed Boiler for Different Operating Modes

CFD Modeling of Ash Deposition Distribution in an Industrial Radiant Syngas Cooler to Enhance the Operation Performance

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Experimental Investigation and Model Validation of the Heat Flux Profile in a 300 MW CFB Boiler

Research on the Heat Transfer Model of Platen Heating Surface of 300 Mw Circulating Fluidized Bed Boilers

Fluidized Bed Ash Cooler Used in A Circulating Fluidized Bed Boiler: an Experimental Study and Application

RADIATION HEAT TRANSFER MODEL OF A CIRCULATING FLUIDIZED BED

Experimental Research of CFB Ash Deposition on Helical Finned Tubes

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

Measurement of Heat Transfer in a 465t/h Circulating Fluidized Bed Boiler

Heat Flux Distribution on Circulating Fluidized Bed Boiler Water Wall

Heat transfer characteristics of fluidized bed heat exchanger in a 300MW CFB boiler

Modeling of Circulating Fluidized Bed Boiler Performance

Study on Model of Ash Fouling Monitoring in Rotary Air Preheater of Coal-Fired Power Plant Boiler