Abstract:In circulating fluidized-bed (CFB) boilers, some residual char is left in the ash when the ash is drained into the rotary ash cooler (RAC). The residue char will combust in the RAC given oxygen is present. It is important to understand and predict the influence of residual char combustion on the heat transfer process in the RAC in order to avoid slagging and fouling inside the RAC. In this paper, an improved heat transfer model of the RAC was developed in which the residual char combustion process was considered. Based on the analysis, the shrinking sphere model was selected to describe the residual char combustion. The improved model was validated by the final ash temperature and cooling water temperature data measured from a few RACs equipped with the coal fired CFB boilers with different steam output. The predictions of the improved model agree well with the field measurement data, within an error range of ±10%. The simulation results also show that the heat released from residual char combustion counts for about 60–80% of the total heat released by ash in the inlet section of the RAC, and the influence of residual char combustion decreases rapidly along the ash flow. The final ash temperature increases accordingly with the increase of inlet carbon content, and decreases with the increases of residual char size. As particle size is larger than 3mm, the final ash temperature changes little at a given carbon content due to a low mass burning rate. It is suggested that combustion of residual char should be considered when the inlet carbon content is over 2.5%; otherwise, the combustion of residual char in the RAC could be neglected.

Research of Heat Transfer Model in Rotary Ash Coolers

Heat-Transfer Model of the Rotary Ash Cooler Used in Circulating Fluidized-Bed Boilers

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Heat Transfer in the Rotary Ash Cooler with Residual Char Combustion Considered

Experimental Study on Heat Transfer in Rolling Ash Cooler

The Study of Unified Thermal Calculation Model of Circulating Fluidized Bed Boiler Based on Experience

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Design and Operation of the Double-Cylinder Rotary Ash Cooler for Large CFB Boilers

Model Research On Material Balance In A Circulating Fluidized Bed Boiler

Numerical investigation of heat transfer in the clinker cooling process of grate cooler

Investigation on the Heat Transfer Model of the External Heat Exchanger of Circulating Fluidized Bed Boilers

Energy and Efficiency Analysis of Ash Cooling Equipment of 300 MW Circulating Fluidized Bed Unit

Simulation of Ash Deposition in Different Furnace Temperature with a 2D Dynamic Mesh Model

Numerical investigation on ash accumulation characteristics of serrated spiral finned tube heat exchanger in waste heat utilization

Development of a heat transfer model for the film boiling regime in a fouling layer

Development of new ash cooling method for atmospheric fluidized beds

A MODEL AND SIMULATION FOR RADIATIVE HEAT TRANSFER IN A BOILER FURNACE

Fluidized Bed Ash Cooler Used in A Circulating Fluidized Bed Boiler: an Experimental Study and Application

RADIATION HEAT TRANSFER MODEL OF A CIRCULATING FLUIDIZED BED

Experimental Investigation and Model Validation of the Heat Flux Profile in a 300 MW CFB Boiler

Numerical simulation and mathematical models of ash deposition behavior considering particle properties and operating conditions