Abstract:Coal and biomass co-combustion in existing utility boilers is a promising option of mitigating the fossil energy crisis and reducing the gaseous emissions of NOx, SOx, and CO2. However, ash-related problems, including fouling, slagging, and corrosion cause damage to the heat exchange tube and reduce boiler efficiency. In an attempt to give better insights into the slagging behavior during coal/biomass combustion, an experimental investigation was conducted to study the growth of slag when coal was co-fired with wood and corn stalk in a 300 kW pilot-scale furnace. For comparison, combustion of pure coal was also conducted. During the experiments, biomass proportions of 5 and 10% by weight were examined. Slags formed on an oil cooled deposition probe were collected, sampled, and analyzed using scanning electron microscopy and X-ray diffraction (XRD). The change in slag thickness with time was obtained by a charge-coupled device monitoring system. With two thermocouples in the probe, the heat flux through the slag could be measured. The slag from pure coal combustion showed a layered structure with different levels of compactness and hardness. The heat flux decreased by 31.7% as the slag grew to 5.19 mm. The results showed that co-firing wood significantly inhibited the slagging behavior. Especially in the 10% wood case, hardly any slag was collected from the probe. Nevertheless, co-firing corn stalk resulted in severe slagging, with a slag thickness of 5.5 and 6.1 mm for two blend ratios. The formation of bubbles in the deposits together with greater deposit thickness caused heat transfer deterioration. XRD results revealed that the influence of co-firing biomass and corn stalk caused quite different changes to mineral species from wood. It was observed that fly ash under different biomass co-firing conditions differed little on mineral compositions.

Numerical Simulation of Fly Ash Deposition in Coal and Corn Stalk Co-Combustion with Dynamic Mesh Technique

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

A general mechanistic model of fly ash formation during pulverized coal combustion

CFD modelling of biomass ash deposition under multiple operation conditions using a 2D mass-conserving dynamic mesh approach

Dynamic CFD modeling and evaluation of ash deposition behaviors during Zhundong coal combustion

Understanding the effects of mesh smoothing methods in the CFD modelling of Zhundong lignite ash deposition

Behavior of Slagging Deposits During Coal and Biomass Co-combustion in a 300 Kw Down-Fired Furnace

Simulating growth of ash deposit in boiler heat exchanger tube based on CFD dynamic mesh technique

Simulation of Ash Deposition in Different Furnace Temperature with a 2D Dynamic Mesh Model

Dynamic Evolution of Impaction and Sticking Behaviors of Fly Ash Particle in Pulverized Coal Combustion

Understanding the Ash Deposition Formation in Zhundong Lignite Combustion Through Dynamic CFD Modelling Analysis

Numerical Simulation of Mixing Capability in Coal-Slurry Mixing Tank

Numerical Simulation of Combustion Process for a Slag Tapping Boiler

Slagging behavior modeling in coal gasifiers using two-way coupled slag model with CFD

Simulation of ash depositing in heat transfer surface with heat flux probe

Investigation of the Slagging Characteristics During Co-Combustion of Shenhua Coal and Corn Stalk: Effect of Deposition Surface

Advanced Modeling Approaches for CFD Simulations of Coal Combustion and Gasification

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Application of Different Combustion Models for Simulating the Co-combustion of Sludge with Coal in a 100 MW Tangentially Coal-Fired Utility Boiler

The Dynamic Model of Pulverized Coal and Waste Plastic Bonded Together in Flight Combustion Process.

Numerical Investigation of Swirl-Stabilized Pulverized Coal Flames in Air and Oxy-Fuel Atmospheres by Means of Large Eddy Simulation Coupled with Tabulated Chemistry