Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

Simulation of Ash Deposit in A Pulverized Coal-Fired Boiler

A general mechanistic model of fly ash formation during pulverized coal combustion

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Simulating growth of ash deposit in boiler heat exchanger tube based on CFD dynamic mesh technique

Research Progress of Numerical Simulation of Slagging in Pulverized Coal Boiler

Dynamic CFD modeling and evaluation of ash deposition behaviors during Zhundong coal combustion

Model of coal slime combustion behavior in CFB boiler

A six-parameter model to predict ash formation in a CFB boiler

Slagging behavior modeling in coal gasifiers using two-way coupled slag model with CFD

Prediction of ash deposition in ash hopper when tilting burners are used

Understanding the effects of mesh smoothing methods in the CFD modelling of Zhundong lignite ash deposition

Modelling of Fly Ash Viscous Deposition and Slagging Prediction of Biomass-fired Boiler

Numerical Simulation of Fly Ash Deposition in Coal and Corn Stalk Co-Combustion with Dynamic Mesh Technique

A Numerical Study of Ash Deposition Characteristics in a 660MW Supercritical Tangential Boiler

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

Prediction on pulverized coal combustion process in the boiler using computer simulation

CFD modeling of sodium transformation during high-alkali coal combustion in a large-scale circulating fluidized bed boiler

Numerical Simulation of Combustion Process for a Slag Tapping Boiler

Understanding the Ash Deposition Formation in Zhundong Lignite Combustion Through Dynamic CFD Modelling Analysis