Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

Semi-empirical Technique for Predicting Ash Size Distribution in CFB Boilers

A six-parameter model to predict ash formation in a CFB boiler

EXPERIMENTAL TECHNIQUE ON COAL ASH FORMATION IN CFB COMBUSTION

A general mechanistic model of fly ash formation during pulverized coal combustion

Six-parameter Model Study of Ash Formation Characteristics of Coals in a Circulating Fluidized Bed Boiler

Model Research On Material Balance In A Circulating Fluidized Bed Boiler

Investigation on the Ash Size Distribution and Attrition During the Coal Combustion in Fluidized Bed

Ash Formation Characteristics of Two Indonesian Coals and the Change of Ash Properties with Particle Size

Experiments on Ash Formation of Different Coals in Circulating Fluidized Bed Combustion

Experimental Investigation On Three Coals Ash Formation

Calculation method for the dynamic total mass balance of CFBC

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

The Ash Formation and Attrition Characteristics of an Indonesia Lignite Coal Ash for a 550 MWe Ultra Supercritical CFB Boiler

TEST STUDY ON THE INFLUENCE OF COAL PARTICLE SIZE UPON ASH-SLAG FORMATION IN CFB BOILERS

Measurements and Prediction of Ash Deposition in a Cyclone-Fired Boiler Operating under Variable Load Conditions

Mass Balance Performance Of A 300mw Cfb Boiler Burning Blend Fuel With Different Mixing Ratio

Investigation of Ash Deposition Dynamic Process in an Industrial Biomass CFB Boiler Burning High-Alkali and Low-Chlorine Fuel

1D modeling on the material balance in CFB boiler

Modeling Research On Char Particle Combustion Behavior In Cfb Condition

Heat-Transfer Model of the Rotary Ash Cooler Used in Circulating Fluidized-Bed Boilers