Abstract:Bituminous coal char particles will differ in morphology, porosity, reactivity, and behavior within the zone II regime (where most practical system operates) due to the influence of maceral, rank, and time-temperaturehistories. Effective boiler design requires simulations that appropriately capture char behavior. Most simulations, however, assume solid spherical particles that have homogeneous physical and chemical properties. Unfortunately, coal and time-temperature-history variations make it impossible to make a direct comparison of morphologies alone using traditional experimental approaches. Thus, here the influences of coal char morphologies on its reaction behavior and physical structure were explored via small-scale atomistic simulations. Three (ashfree) chars of solid, thick-, and thin-walled morphologies were examined. The atomistic representations had similar to 143000 carbon atoms, comprised of similar polycyclic aromatic hydrocarbons (PAH) sizes and stacking distributions. While these structures are far below the actual particle size, the approach permits a direct comparison with a level of control not possible via physical experimentation. The densities of the thick- and thin-walled char models were similar to literature observations (apparent and helium densities). The specific surface area for the solid, thick-, and thin-walled char models were 110, 368, and 509 m(2)/g, with the latter two being closer to experimental data. A simplified combustion simulation (diffusion and oxygen proximity calculations) demonstrated that the char morphology had a significant impact upon their relative reactivities. The thin-walled structure had the highest overall reactivity due to greater reactive surface access, while the solid and thick-walled structure was respectively 27 and 23% lower. The reaction rate profiles with char conversion for these three structures are close to the experimental observations for pulverized bituminous coal chars, where the rate peak occurs at similar to 20% conversion. The changes in char size, density, and specific surface area (with char conversion) indicated the thick-walled structure was more similar to the literature data. These atomistic approaches have the potential to aid in exploring the reaction behavior of char particles with various morphologies and complicated structures. With scale-up additional behaviors such as particle fragmentation and ash behavior could be incorporated.

Modeling Research On Char Particle Combustion Behavior In Cfb Condition

A general mechanistic model of fly ash formation during pulverized coal combustion

Measurements and Modelling of Oxy-Fuel Coal Combustion

Modeling Research on the Burnout Characteristics of Fine Anthracite Char Particle in CFB Combustor

Research on Carbon Content in Fly Ash from Circulating Fluidized Bed Boilers

Modelling the Combustion of Thermally Thick Biomass Particles

Reduced-order model of char burning for CFD modeling

A Percolation Model of Fly Ash Formation During the Combustion of Non-Uniform Porous Char

CFD Simulation of the Steam Gasification of Millimeter-Sized Char Particle Using Thermally Thick Treatment

Discrete Ash Inhibition Model of Char Burning for the CFD Modeling of Precalciner

Experimental and Modeling Study on Char Combustion

Coal combustion efficiency in CFB boiler

Pressurized Oxy-Fuel Combustion of a Char Particle in the Fluidized Bed Combustor

Heat Transfer in the Rotary Ash Cooler with Residual Char Combustion Considered

Combustion Model for a CFB Boiler with Consideration of Post-Combustion in the Cyclone

The Influence of Char Particle Morphology on Char Burnout Behavior by Atomistic Simulation

Postcombustion and Its Influences in 135 Mwe Cfb Boilers

Experimental and Kinetics Studies on the Evolution and Effects of Ash Film During Pulverized Coal Char Combustion

Study on Dynamic Characteristics of Residual Char of CFB Boiler Based on CPFD Method

Carbon Formation Mechanism in Fly Ash of Circulating Fluidized Bed Boilers

Combustion Modeling Of Cfb Boiler Furnace Based On An Euler-Euler Approach