Abstract:Electrostrictive materials, hard ceramics and soft polymers, have been used as precision actuators in many engineering applications. This study is to examine bang–bang control performance of a hybrid Plexiglas beam laminated with polymeric electrostrictive (RTV 270) actuator and piezoelectric polyvinylidene fluoride (PVDF) sensor layers using both analytical and experimental techniques. Material characteristics are calibrated via static testing first; a hybrid beam model is then fabricated and an experiment set-up, consisting of a bang–bang controller, high-voltage amplifier, data acquisition system and the hybrid beam system, is designed to evaluate vibration control characteristics (i.e., damping ratio estimation) of the hybrid beam subjected to various control conditions. Due to the quadratic behaviour of electrostrictive materials, the controller activates the electrostrictive actuator only in upward motion of the beam, with reference to signals generated from the piezoelectric sensor. Base on constitutive equations and dynamic/control characteristics, a mathematic hybrid beam model is also derived from the electrostrictive thin shell theory and its dynamic responses, based on the finite difference discretization, are simulated to predict damping ratios resulting from control forces induced by the electrostrictive actuators. Dynamic responses (with and without control) of the physical beam model are measured and compared with simulation results. Favourable comparison suggests that the mathematical model describes the experimental model very well and its application to other advanced structures can be proceeded.

(100) Composite Beam Structure Formed by Masked-Maskless Etch of Silicon

Composite Cantilever Beam-Mass Structure Gyroscope by A Novel Etching Technology

Study on maskless etching of silicon symmetric beam-mass structure in aqueous KOH

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

A novel capacitive accelerometer with an eight-beam-mass structure by self-stop anisotropic etching of (1 0 0) silicon

Single wafer fabrication of a symmetric double-sided beam-mass structure using DRIE and wet etching by a novel vertical sidewall protection technique

A Piezoresistive Accelerometer with a Novel Vertical Beam Structure

Fabrication of hollow composite structure microfluidic double-end clamped beam

A Micromachined Piezoresistive Angular Rate Sensor with a Composite Beam Structure

A Novel Sandwich Capacitive Accelerometer with A Double-Sided 16-Beam-mass Structure

A New Symmetrical Beam-Mass Structure for Accelerometers by Anisotropic Etching Without Convex Corner Compensation

Maskless Etching Of Three-Dimensional Silicon Structures In Koh

A Single-Sided Multilevel Structure for Silicon Pressure Transducers by ''Masked-Maskless'' Etching Technology

A Micromechanical Structure Eliminating Lateral Effect of Silicon Accelerometer

Design and testing of a hybrid polymeric electrostrictive/piezoelectric beam with bang–bang control

A Novel Fabrication Methodology for Micromachined Sensor-Arrays with Multi-Thickness Configuration

A Novel Z-Axis Capacitance Accelerometer with Highly Symmetrical 16-Beam Structure

A High-Performance Micromachined Piezoresistive Accelerometer with Axially Stressed Tiny Beams

A novel sandwich capacitive accelerometer with a symmetrical structure fabricated from a D-SOI wafer

Fabrication of a MEMS Capacitive Accelerometer with Symmetrical Double-Sided Serpentine Beam-Mass Structure

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer