Abstract:Ti-6Al-4V alloy, as a typical difficult-to-machine material, is prone to problems such as large cutting forces, high cutting temperatures, and serious tool wear during the cutting process. Ti 1-x Al x N coated tools are widely used in machining Ti-6Al-4V alloys. The main wear forms of Ti 1-x Al x N coated tools are coating cracking and delamination. After the coating has been delaminated, the tool substrate is in direct contact with the workpiece material, aggravating tool wear and shortening the tool life. Therefore, the milling process of Ti 1-x Al x N coated tool cutting Ti-6Al-4V alloy was performed using FEM. The effects of Al contents (Ti 0.48 Al 0.52 N, Ti 0.38 Al 0.62 N), coating thickness (2, 3, 4 μm), and tool substrate (Cemented Carbide Grade K, M, P) of Ti 1-x Al x N coated tools on the cutting performance (cutting force, cutting temperature, maximum principal stress, the temperature and stress of coating-substrate interface) and tool wear were discussed. The influence of the maximum principal stress, the temperature and stress of coating-substrate interface on tool wear were analyzed. This paper can provide a reference for the design and optimization of Ti 1-x Al x N coated tools by investigating the wear of Ti 1-x Al x N coated tools cutting titanium alloys, which can be used to slow tool wear and prolong tool life.

In-situ observation of single - point wear of PM Al-Ti alloy

In-situ observation of single-point wear of PM Al-Ti alloy

Microstructure and Sliding Wear Behavior of PM Alloy Al10Ti after Thermal Exposure

Dry sliding wear of PM Al-10Ti alloy

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Dry sliding wear of MA/PM Al-10Ti alloy

Contributions of the Particulate Reinforcement to Dry Sliding Wear Resistance of Rapidly Solidified Al-Ti Alloys

Analysis of tool wear of TiAlN coated tool, machined surface morphology and chip during titanium alloy milling

Observing and Modeling the Wear Process of Heterogeneous Interface

In-situ friction and wear study of SiCα/SiCβ and Al2O3-TiC-Co composite ceramics

Effect of Al Content on the Wear Evolution of Ti1-xAlxN-Coated Tools Milling Ti-6Al-4V Alloy

Preparation and Characterization of In Situ (TiC-TiB2)/Al-Cu-Mg-Si Composites with High Strength and Wear Resistance

Finite element analysis of Ti 1-x Al x N coated tools cutting performance and tool wear during Ti-6Al-4V milling

In-Situ Observation and Study of the Unlubricated Wear Process

Wear Properties of NiAl Based Materials

Analysis of the abrasive wear mechanism by successive observations of wear processes in a scanning electron microscope

In-situ test of full field deformation and chip formation mechanism during machining of Ti 2 AlNb intermetallic with digital image correlation method

Wear Behavior of TiN/TiAlSiN Nanocomposite Multilayer Coatings from Ambient Temperature to Medium Temperature

Investigation of Friction and Wear Behavior of NiAl-based Alloys at Room Temperature

Study on In-Situ Tool Wear Detection during Micro End Milling Based on Machine Vision

Investigation on the relationship between reinforcing behavior of TiN and wear resistance of AlCoCrCuNiTi high-entropy alloy coating