Abstract:Recently, many studies have reported the ultralow friction coefficient of sliding friction between rigid solid surfaces in aqueous lubrication. A running-in process that goes through high-friction and friction-decreasing regions to a stable ultralow friction region is often required. However, the role of the friction-decreasing region is often ascribed to tribofilm formation in which complexity hindered the quantitative description of the running-in process and the prediction of its subsequent lubrication state. In this work, the frictional energy ( Ef) dissipated in the running-in process of a poly(oligo(ethylene glycol) methyl ether acrylate) aqueous lubrication was related to the wear of solid surfaces under different conditions and lubrication states. Experimental results indicated that the high-friction region was in a boundary lubrication state, contributed to most of the wear, and significantly reduced the contact pressure, whereas the friction-decreasing region was in a mixed lubrication state, contributed only to the slight and slow removal of materials, and slightly reduced the contact pressure. Therefore, by establishing relationships among the wear scar diameter, Ef, and the Stribeck curve of the tribological system, the subsequent lubrication state after a running-in process under various working loads and sliding speeds could be quantitatively predicted. The running-in experiments with different aqueous lubrication systems showed good agreement with the prediction of this method. This investigation provides an effective method for the wear and lubrication state prediction after a running-in process, further proving the importance of the Stribeck curve for a lubrication system. This study may also have important implications for the strategy design of the running-in process in various industrial applications.

In-Situ Observation and Study of the Unlubricated Wear Process

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Friction and Wear On-Line Monitoring and Wear Mechanism Analysis under Dynamic Loading Manners

In-situ observation of single-point wear of PM Al-Ti alloy

Analysis of the abrasive wear mechanism by successive observations of wear processes in a scanning electron microscope

In-situ observation of single - point wear of PM Al-Ti alloy

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

In Situ Observation of Nano-Abrasive Wear

In-situ Characterization of Three Dimensional Worn Surface under Sliding-Rolling Contact

A FRACTURE-INDUCED ADHESIVE WEAR CRITERION AND ITS APPLICATION TO THE SIMULATION OF WEAR PROCESS OF THE POINT CONTACTS UNDER MIXED LUBRICATION CONDITION

In-Situ Observation and Discrete Element Simulation of Solid Graphite Lubrication Mechanism

Experimental Investigate of the Wear and Friction Performance Considering Effects of Surface Topography and Lubricant

Study on the variation of 3D topography of specific spot on sliding wear surface

On Lubrication States after a Running-In Process in Aqueous Lubrication.

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Finite element simulation and experimental test of the wear behavior for self-lubricating spherical plain bearings

Transition of frictional states and surface roughness effects in lubricated contacts

A Friction Force Microscopy Study on the Surface of Au Film, Cd-Disk and Lb Film

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Observing and Modeling the Wear Process of Heterogeneous Interface