Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

Analysis of the abrasive wear mechanism by successive observations of wear processes in a scanning electron microscope

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

The effect of hardness on the transition of the abrasive wear mechanism of steels

Abrasive Wear Mechanisms in Steels

Friction and Wear Mechanisms of 316L Stainless Steel in Dry Sliding Contact: Effect of Abrasive Particle Size

In-Situ Observation and Study of the Unlubricated Wear Process

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

In-situ observation of single-point wear of PM Al-Ti alloy

In-situ observation of single - point wear of PM Al-Ti alloy

Asperity level characterization of abrasive wear using atomic force microscopy

Mechanisms of abrasive wear in lubricated contacts

An examination of a mild wear process

Friction coefficient and wear mode transition in micro-scale abrasion tests

Contact Analysis of Abrasive Wear

Friction and Wear of Si3N4 Ceramic/stainless Steel Sliding Contacts in Dry and Lubricated Conditions

Wear Mechanisms of the Working Surface of Gears after Scuffing Tests

Micro- and Nanowear of Self-Mated Steel Generated and Studied With an AFM at the Single Asperity Level

Dynamic changes of mechanical properties induced by friction in the Archard wear model

Investigation of the wear behaviors of Ag/Cu multilayers by nanoscratch

Fundamental abrasive contact at high speeds: scratch testing in experiment and simulation

Wear phenomena in chemical mechanical polishing