Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

A study of abrasive wear under three-body conditions

Novel three-body nano-abrasive wear mechanism

Friction and Wear Mechanisms of 316L Stainless Steel in Dry Sliding Contact: Effect of Abrasive Particle Size

Abrasive Wear Mechanisms in Steels

Analysis of the abrasive wear mechanism by successive observations of wear processes in a scanning electron microscope

Tribological mechanisms of slurry abrasive wear

Mechanisms of abrasive wear in lubricated contacts

Contact Analysis of Abrasive Wear

Coupling fractal model for adhesive and three-body abrasive wear of AISI 1045 carbon steel spool valves

An Analytical Model of Mechanistic Wear of Polymers

Finite element analysis of sliding wear on the borided AISI 316L stainless steel

A parameter-free mechanistic model of the adhesive wear process of rough surfaces in sliding contact

A story of two transitions: From adhesive to abrasive wear and from ductile to brittle regime

Modeling Analysis of Abrasive Wear

Abrasive and adhesive wear behaviour of metallic bonds in a synthetic slurry test for wear prediction in reinforced concrete

Abrasive wear mechanisms and their relation to rock properties

Micromechanics of material detachment during adhesive wear: A numerical assessment of Archard's wear model

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact

Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials