Abstract:The existing erosion models of abrasive gas jet tend to neglect the effects of the rebounding abrasive. To address this shortcoming, abrasive wear tests were conducted on limestone by using an abrasive gas jet containing different types of particles and with different standoff distances. The results indicate that erosion pits have the shape of an inverted cone and a hemispherical bottom. An annular platform above the hemispherical bottom connects the bottom with the side of the pit. The primary cause of the peculiar pit shape is the flow field geometry of the gas jet with its entrained particles. There is an annular region between the axis and boundary of the abrasive gas jet, and it contains no abrasive. Particles swirling around the axis form a hemispherical bottom. After rebounding, the abrasive with the highest velocity enlarges the diameters of both the hemispherical bottom and erosion pit and induces the formation of an annular platform. The surface features of different areas of the erosion pit are characterized using a scanning electron microscope (SEM). It can be concluded that the failure modes for different locations are different. The failure is caused by an impact stress wave of the incident abrasive at the bottom. Plastic deformation is the primary failure mode induced by rebounding particles at the sides of the hemispherical bottom. The plastic deformation induced by the incident abrasive and fatigue failure induced by the rebounding abrasive are the primary failure modes on the annular platform. Fatigue failure induced by rebounding particles is the primary mode at the sides of the erosion pits. The rock failure mechanism that occurs for particles with different hardness is the same, but the rock damaged by the hard abrasive has a rougher surface.

Abrasive wear mechanisms and their relation to rock properties

Abrasive Wear Mechanisms in Steels

Principles of abrasive wear

Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials

Wear of Cutting Tools in Hard Rock Excavation Process: A Critical Review of Rock Abrasiveness Testing Methods

Abrasive Wear Mechanisms of S235JR, S355J2, C45, AISI 304, and Hardox 500 Steels Tested Using Garnet, Corundum and Carborundum Abrasives

Contact Analysis of Abrasive Wear

Tribology in mining: Highlights in iron ore abrasiveness

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

Tribological mechanisms of slurry abrasive wear

Abrasive and adhesive wear behaviour of metallic bonds in a synthetic slurry test for wear prediction in reinforced concrete

Some metallurgical factors controlling the adhesive and abrasive wear resistance of steels. A review

Comparative Analysis of the Influence of Chemical Composition and Microstructure on the Abrasive Wear of High-Strength Steels

Analysis of Tribological Properties of Hardfaced High-Chromium Layers Subjected to Wear in Abrasive Soil Mass

Resistance to Abrasive Wear with Regards to Mechanical Properties Using Low-Alloy Cast Steels Examined with the Use of a Dry Sand/Rubber Wheel Tester

Asperity level characterization of abrasive wear using atomic force microscopy

Assessment Possibilities of the Quality of Mining Equipment and of the Parts Subjected to Intense Wear

A study of abrasive wear under three-body conditions

Waviness Affects Friction and Abrasive Wear

Erosive Wear Mechanism of Metal Materials Used in Hydraulic Machines

Wear Mechanism of Abrasive Gas Jet Erosion on a Rock and the Effect of Abrasive Hardness on It