A study of abrasive wear under three-body conditions

E. Rabinowicz,L.A. Dunn,P.G. Russell

DOI: https://doi.org/10.1016/0043-1648(61)90002-3

IF: 4.695

1961-09-01

Wear

Abstract:Measurements have been made of the abrasive wear rates of metals being slid together while their interface was provided with copious amounts of powdered abrasive (3-body abrasion). The quantitative relations between the wear rates and time of sliding, material hardness and abrasive grain size were determined, and found to be similar to those prevailing during 2-body abrasion,i.e., during the sliding of metals against abrasive-covered paper. The effects of moisture and of abrasive flow rate were investigated, and good reproducibility was found when these two variables were controlled.A simple quantitative expression for abrasive wear rate is developed, and the abrasive wear data of a number of earlier investigators is analysed in terms of this expression. Abrasive wear rates during 3-body abrasion are about 10 times less than during 2-body abrasion, probably because the average loose abrasive grain spends 90% of its time rolling and only 10% of its time abrading the sliding surfaces between which it is situated.

engineering, mechanical,materials science, multidisciplinary