Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

Hardness Effect on Three-Body Abrasive Wear Under Fluid Film Lubrication

Influence of Abrasive Hardness on Erosion Wear of Abrasive Air Jets

Mechanisms of abrasive wear in lubricated contacts

Hardness Difference Effect of Biomimetic Surface with Hard-Soft Structure on Oil - Lubrication Wear Resistance

The effect of hardness on the transition of the abrasive wear mechanism of steels

Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials

A study of abrasive wear under three-body conditions

An experimental simulation of cutting wear in three-body abrasion

Tribological Properties of Hydrogenated Nitrile Rubber in Confrontation with Hard Particles under Different Axial Loads

Investigation of the Abrasive Wear Behavior of WC/Co Hardmetals

Dependence of Wear Behaviors of Hardmetal Yg8b on Coarse Abrasive Types and Their Slurry Concentrations

Effect of Dual Hardness Combinations on Wear Resistance of Laser Prepared Bionic Grey Iron Surfaces.Effect of Dual Hardness Combinations on Wear Resistance of Laser Prepared Bionic Grey Iron Surfaces

Study Of Wear Resistance Of Several Materials Under Hard And Soft Particle Abrasion

Variation of Wear Behavior of H13 Steel Sliding Against Different-Hardness Counterfaces

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

Three-body abrasion behavior of ultrafine WC–Co hardmetal RX8UF with carborundum, corundum and silica sands in water-based slurries

Effect of Fluid Pressure on Adhesive Wear of Spherical Contact

Effect of In-Situ (ti&w)c Multiphase Particles on Three-Body Abrasive Wear of High Chromium Cast Iron

Effect of Hardness on Fretting Wear Behavior of Worm Gear Steel Pairs

Effect of Hardness Ratio on the Wear Performance and Subsurface Evolution of Ni3Al Matrix Composites

Contrast Role of Third Body Layer and Hard Abrasives in the Wear Process of a TiAlSiN Hardness-Modulated Multilayer Coating: A Case Study on the Effect of Normal Load and Velocity