Abstract:The graphite floating ring is a key sealing element of the turbopump of aeroengines. Its wear induced by frequent flotation during its operation can result in stress concentration and microscopic cracks in its seal end face, more leakage from its sealing surface, a lower engine efficiency, and even serious safety concerns. However, there are currently no published studies regarding the modeling of the end face wear of the floating ring seal. This work presents a new fractal model for predicting the wear rate and wear evolution of the end face of the floating ring seal. Firstly, a new normal fractal contact model was implemented by microscopically considering the deformation mechanism, interaction forces, and flash points of the asperities on the end face of the floating ring. On this basis, a fractal model was built to predict the wear of the end face of the floating ring according to its wear mechanism and the corrected Archard theory. The wear rates predicted according to this model are in good agreement with the test results. The simulation results show that (i) the depth wear rate of the end face of the floating ring first decreases and then increases as the fractal dimension D increases (the minimum is reached when the fractal dimension ranges from 1.60 to 1.725); (ii) the depth wear rate of the end face of the floating ring increases as the characteristic scale G , friction factor f , floatation speed of the floating ring v , and end face pressure P increase; (iii) the impact of the end face pressure on the depth wear rate is minimum when the fractal dimension ranges from 1.60 to 1.65; (iv) the flotation displacement of the floating ring cannot exceed 12 μm when the engine speed is higher than 30,000 r/min.

Coupling fractal model for adhesive and three-body abrasive wear of AISI 1045 carbon steel spool valves

Coupling behavior between adhesive and abrasive wear mechanism of aero-hydraulic spool valves

Modeling and simulation of wear for alignment mechanism of large aircraft component

A study on building and testing fractal model for predicting end face wear of Aeroengine's floating ring seal

A Mixed Lubrication Model for Predicting the Lubrication Performance Degradation Behavior of Slipper Pair in Early Wear Failure

Normal Load of Internal Combustion Engine Junction Based on Fractal Theory of Thermal Elasto-Plastic Contact

Modification methodology of fretting wear in involute spline

Contact Analysis of Abrasive Wear

A mixed-lubricated friction model of water lubricated bearing based on fractal theory

A FRACTURE-INDUCED ADHESIVE WEAR CRITERION AND ITS APPLICATION TO THE SIMULATION OF WEAR PROCESS OF THE POINT CONTACTS UNDER MIXED LUBRICATION CONDITION

Application of Fractal Contact Model in Dynamic Performance Analysis of Gas Face Seals

Frictional Study on 30CrNi2MoVA Steel Based on Experiments and Finite Element Simulation: Wear Prediction

Impact Analysis of Worn Surface Morphology on Adaptive Friction Characteristics of the Slipper Pair in Hydraulic Pump

Coupling failure dynamics of tooth surface morphology and wear based on fractal theory

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact

Modeling adhesive and abrasive wear phenomena in fretting interfaces: A multiphysics approach coupling friction energy, third body and contact oxygenation concepts

Finite element analysis of fretting wear considering variable coefficient of friction

Prediction and Experimental Validation of Aviation Floating Involute Spline

Wear Characteristics of the Material Specimen and Method of Predicting Wear in Floating Spline Couplings of Aero-Engine

Correlating numerical modelling with experimental studies to quantify the wear resistance of high-carbon chromium bearing steel in mixed lubrication

The Friction and Wear Model of Steels and Their Probable Statistic Calculations