Abstract:In this paper, the fretting wear behaviour of steel wires working in coal mining technology is studied numerically. In past studies, the fretting process of steel wires was carried out numerically considering that the coefficient of friction (COF) and wear coefficient (WC) are constant parameters. However, it has been noticed experimentally that COF increases up to a certain number of fretting cycles and then becomes constant, i.e. a steady-state stage, depending on the loading conditions. This increase in COF during the fretting process is also known as the running-up stage. The fretting wear model is modified to evaluate the influence of the varying coefficient of friction (VCOF), which is associated with the variable wear coefficient (VWC), so the influence of VWC is also considered. The subroutine UMESHMOTION used to implement the wear law is also modified to study the effect of VCOF and VWC. Therefore, in this study, the numerical results of a three-dimensional finite element (FE) model are compared, with analytical results of contact area and contact stresses, and with experimental results of peak wear depth. After validating the FE model, the wear scar, the increasing wear depth, wear volume, and the decreasing contact stress with increasing fretting cycles are determined numerically considering VCOF and VWC using cycle jump approach. The energy dissipation effect of frictional force and fretting amplitude is also studied for varying interaction properties of fretting wear models. The numerical simulations are performed by considering both elastic and plastic material properties to analyse the influence of varying interaction properties on fretting wear models at the running-up stage. The results indicate that the VWC model exhibits comparable impacts on both the elastic and plastic models. The results also show that the VWC fretting wear model leads to higher wear scar, wear volume, and wear depth values at the running-up stage as well as at the steady state stage, which are close to the experimental data.

The Friction and Wear Model of Steels and Their Probable Statistic Calculations

Abrasive Wear Model for Lubricated Sliding Contacts

Coupling Fractal Model for Fretting Wear on Rough Contact Surfaces

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact

Adhesion-fatigue Dual Mode Wear Model for Fractal Surfaces in AISI 1045 Cylinder-Plane Contact Pairs

Wear prediction for metals

Contact Analysis of Abrasive Wear

A lubricated wear model for determining wear surface geometry on journal-bearing surfaces

Finite element analysis of fretting wear considering variable coefficient of friction

Experimental Method of Tribological Modelling of Different Coatings of Stainless Steel

A New Dual-Mode Wear Model of Abrasion–Fatigue for Plane (100Cr6)-Cylinder (C45E4) Steel Pairs with Fractal Surfaces

Frictional temperature field and its relationship to the transition of wear mechanisms of steel 52100

Wear Rate, Frictional Temperature, and Energy Consumption of Steel 52100 with Different Microstructures During Sliding

Coupling fractal model for adhesive and three-body abrasive wear of AISI 1045 carbon steel spool valves

Wear Calculation and Life Prediction Model of Disc Brake Based on Elastoplastic Contact Mechanics

Modeling adhesive and abrasive wear phenomena in fretting interfaces: A multiphysics approach coupling friction energy, third body and contact oxygenation concepts

Numerical Study on Wear Evolution and Mechanical Behavior of Steel Wires Based on Semi-Analytical Method

Simulation of fretting wear in steel wires under variable coefficient of friction and variable wear coefficient

Finite Element Analysis of Stainless Steel Under Coupled Deformation and Friction Condition

Frictional Study on 30CrNi2MoVA Steel Based on Experiments and Finite Element Simulation: Wear Prediction

Frictional Temperature Field and Wear Behavior of Steel 52100 with Different Microstructures