Abstract:Providing high-quality machinery and equipment in technical terms is an activity aimed primarily at ensuring the high reliability of nodes. Reliability of machinery and equipment is mainly characterized by resistance to destructive processes. Mutual displacement of parts causes destructive friction phenomena, the intensity of which can be intensified by the interaction of specific technological environments. The article presents the results of research on ring-on-ring samples made of C45 steel in the non-heat-treated state, which were subjected to mechanical, corrosive, and abrasive wear and various combinations of them. The main purpose of the study was to determine the wear that results from the action of destructive friction and corrosive processes with the presence of abrasive material in the tribological node. The results supplement the knowledge of material wear under the simultaneous action of several destructive factors. Based on the study, it was noticed that the sum component of mechanical-abrasive-corrosive interactions is about 40-50% of the total wear. Mass loss resulting from simultaneous mechanical and abrasive interactions is equal about one-third of the total wear. In addition, it was observed that the effects of the interactions of friction (mechanical), corrosive and abrasive excitations are synergistic in nature, which lead to increases in the total wear of the tested samples made of steel. The results of the research are of practical importance and allow for wear-optimal selection of material in the friction node of modern machinery and equipment.

Friction coefficient and wear mode transition in micro-scale abrasion tests

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Friction and Wear of Metals under Micro-abrasion, Wet and Dry Sliding Conditions

EFFECTS OF SURFACE PREPARATION ON FRICTION AND WEAR IN DRY SLIDING CONDITIONS

Frictional temperature field and its relationship to the transition of wear mechanisms of steel 52100

Friction and dry sliding wear behaviour of cermets

Micro-characterization of macro-sliding wear for steel

Friction and Wear Mechanisms of 316L Stainless Steel in Dry Sliding Contact: Effect of Abrasive Particle Size

Waviness Affects Friction and Abrasive Wear

Tribological mechanism of micro/meso/macroscopic textured surfaces under different normal forces, relative velocities, and sliding directions

Studies of Simultaneous Friction and Corrosive Processes in the Presence of Abrasive Particles

Wear Rate, Frictional Temperature, and Energy Consumption of Steel 52100 with Different Microstructures During Sliding

Assessment of Surface Wear Properties with Initial Macro Crack Defects Using On-Line Visual Ferrography and Sem Methods

Analysis of the abrasive wear mechanism by successive observations of wear processes in a scanning electron microscope

Friction and Wear On-Line Monitoring and Wear Mechanism Analysis under Dynamic Loading Manners

Friction and Material Transfer in Micro-Scale Sliding Contact Between Aluminium Alloy and Steel

FEM computation of groove ridge and Monte Carlo simulation in two-body abrasive wear

Frictional Temperature Field and Wear Behavior of Steel 52100 with Different Microstructures

Investigation of the Abrasive Wear Behavior of WC/Co Hardmetals

Evolution of Bi-Gaussian Surface Parameters of Silicon-Carbide and Carbon-Graphite Discs in a Dry Sliding Wear Process

Wear Behavior Of Steel 1080 With Different Microstructures During Dry Sliding