Abstract:Surface texturing is an effective technology for enhancing lubrication and anti-wear properties through hydrodynamic effects and secondary lubrication. In this study, two types of variable-depth groove textures were designed to enhance the lubrication performance of friction pairs. Based on theoretical analysis, the coefficient of friction (COF), wear characteristics, and triboelectric open-circuit voltages produced by different textures were evaluated in a series of experiments. Using a friction testing setup, scanning electron microscopy, energy dispersive spectrometry, an electrometer (Keithley 6514), Raman spectroscopy, surface microtopography, and lubrication mechanisms were revealed. First, two types of variable-depth groove textures were designed based on computational fluid dynamics. Second, SiC samples with these textures were fabricated using laser surface texturing technology, and ball–disk rotary friction experiments were performed. During the friction tests, the shallow inner and deep outer (SDT) groove textures exhibited a lower COF at medium and low speeds under varying loads. Finally, the lubrication mechanism was attributed to the synergistic effect of four factors: the hydrodynamic effect of the lubricant, enhanced ability of debris expulsion, oxide tribofilms at the interface, and polarization electric field generated at the solid–liquid interfaces between the lubricant and friction pair. The results indicate that the minimum COF of the SDT texture can be reduced to 0.025. These insights offer valuable guidance for design methods and new lubrication mechanisms for enhancing the lubrication and anti-wear properties of friction pairs in mechanical systems.

Evolution of Bi-Gaussian Surface Parameters of Silicon-Carbide and Carbon-Graphite Discs in a Dry Sliding Wear Process

The Bi-Gaussian Theory to Understand Sliding Wear and Friction

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Dry Sliding Behavior and Particulate Emissions of a SiC-graphite Composite Friction Material Paired with HVOF-Coated Counterface

Dry sliding tribological behavior of C/SiC under different load and speed

EFFECTS OF SURFACE PREPARATION ON FRICTION AND WEAR IN DRY SLIDING CONDITIONS

Dry Wear Behaviors of Graphite/cermet Self-Lubricating Composite under Different Sliding Conditions and Simulation of Temperature Field

Effect of sliding speed on friction and wear behaviors of RMI-C/C-SiC composites

Wear Mechanism and Three-phase Synergistic Effect of Self-mated SiC/Si/Graphite Composites in Unlubricated Sliding

Tribo-Map of CVD Diamond Film Sliding Against Silicon Nitride in Air

Sliding Behaviour of Friction Material Against Cermet Coatings: Pin-on-Disc Study of the Running-in Stage

Tribological Properties of Si-Doped Graphite-Like Amorphous Carbon Film of PEEK Rubbing with Different Counterparts in SBF Medium

Characterisation Of Tribological Behaviour Of Silicon And Ceramic Coatings Under Repeated Sliding At Micro-Scale

The Relationship between Cyclic Multi-Scale Self-Organized Processes and Wear-Induced Surface Phenomena under Severe Tribological Conditions Associated with Buildup Edge Formation

Tribological Behavior and Wear Mechanism of Cu-SiO2 Sintered Composite under Different Sliding Speeds

Mechanical and tribological properties of Si and W doped diamond like carbon (DLC) under dry reciprocating sliding conditions

Tribological Behavior of SiC Coating on C/C Composites Against SiC and WC under Unlubricated Sliding

Dry Sliding Friction and Wear Behavior of Woodceramics/al–si Composites

In-situ friction and wear study of SiCα/SiCβ and Al2O3-TiC-Co composite ceramics

Study on the Friction-Reducing Mechanisms of Surface Texture Cemented Carbide under Dry Sliding

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication