Abstract:For the successful application of boundary lubrication, detailed investigations about the influence of preparation process on molecular films are needed. In this paper, a specially designed device was used for the film preparation. The scanning electron microscope (SEM) combined with atomic force microscope (AFM) was employed to characterize the surface morphology and nanotribological behavior of molecular films. After the liquid phase deposition, molecular films are randomly and densely distributed over Ti-doped diamond-like carbon (Ti-DLC) substrates. Through rigorous surface treatments, island-like molecular films were finally achieved on substrate surfaces. The surface friction of molecular films is obviously lower than that of Ti-DLC surfaces. Then, pin-on-disk tribotests were performed to study the macrofriction behavior of molecular films under different preparation parameters. Based on the orthogonal experiment, the effect of five preparation parameters (solution weight percent, smearing force and processing time of three smearing steps) on initial friction coefficient of molecular films was investigated. The results indicated that the order of significance levels is as follows: processing time of the second smearing step > solution weight percent > processing time of step 1 > processing time of step 3 > smearing force. For the purpose of friction reduction, the appropriate level ranges are 0.75% (Solution), 2.5 N-15 N (Force), 1 min-10 min (Step 1), 1 min-2 min (Step 2) and 1 min, 2 min, 5 min and 15 min (Step 3). The initial friction coefficient under the optimized conditions is around 0.112, and the equilibrium friction coefficient is around 0.162, which is lower than that of unlubricated Ti-DLC substrates.

Effects of Test Parameters on the Frictional Properties of Al/Diamond-like Carbon Core-shell Nanostructure-textured Surfaces

Contact size effects on the friction and wear of amorphous carbon films

Effects of sp3 bond ratio and modulation ratios on nanotribology behaviors of diamond-like carbon coatings investigated using atomistic nanoscratching simulations

Tribological Behavior of Diamond-Like Carbon Film with Different Tribo-Pairs: A Size Effect Study

Afm/Ffm Study Of Micro/Nano-Tribological Properties Of Diamond-Like Carbon Film

Microstructure and Tribological Properties of Diamond-Like Carbon and Tialsicn Nanocomposite Coatings

Nanofriction Behaviors Between Silicon-Doped Diamond-Like Carbon Films under Different Testing Conditions

Preparation, Characterization and Investigation of Molecular Films Coated on Diamond-Like Carbon Substrate

Atomic-Scale Understanding on the Tribological Behavior of Amorphous Carbon Films under Different Contact Pressures and Surface Textured Shapes

Frictional and Wear Behavior of Micro-Crystalline and Nano-Crystalline Diamond Films

Synergistic effect of graphene and nanodiamonds to achieve ultra-low friction on rough DLC coatings

The Effect of Carbon Structure of DLC Coatings on Friction Characteristics of MoDTC-Derived Tribofilm by Using an In Situ Reflectance Spectroscopy

Friction and Wear Performance of Hydrogenated Diamond-Like Coatings with Non-Metal Element Complex Dopants Against Alumina in Ambient Air

Wear and friction between smooth or rough diamond-like carbon films and diamond tips

Nanocoatings Tribology

Effect of Surface Morphology on the Frictional Behaviour of Hot Filament Chemical Vapour Deposition Diamond Films

A study of the wear mechanism of diamond-like carbon films

Effect of normal load and roughness on the nanoscale friction coefficient in the elastic and plastic contact regime

Fabrication and Tribological Properties of the Laser Textured SiC Cylinders with Diamond Coating

Mechanical and Unlubricated Tribological Properties of Titanium-Containing Diamond-Like Carbon Coatings

Viscoplastic Properties and Tribological Behavior of Diamond-Like Carbon Films Using Nanoindentation and Nanoscratch Tests