Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Tribological mechanism of micro/meso/macroscopic textured surfaces under different normal forces, relative velocities, and sliding directions

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Wear Rate, Frictional Temperature, and Energy Consumption of Steel 52100 with Different Microstructures During Sliding

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Atomic-Scale Understanding on the Tribological Behavior of Amorphous Carbon Films under Different Contact Pressures and Surface Textured Shapes

Effect of surface roughness on sliding friction in lubricated contacts-reciprocal experiment study

Characterisation Of Tribological Behaviour Of Silicon And Ceramic Coatings Under Repeated Sliding At Micro-Scale

Fundamental wear mechanism of metals

A critical assessment of surface texturing for friction and wear improvement

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

Effect Of Surface Energy On Shearing Of Metal Asperities Contact At The Nanoscale

Research in Improving Tribology Performance by Surface Texturing

Empowering Chronically Ill Patients and Caregivers using Remote Monitoring Technology

Tribological mechanisms of slurry abrasive wear

Micro-Tribology

Experiment and Modelling of Texture and Sliding Direction Dependence on Finger Friction Behavior

A Study of Tribological Performance Prediction Based on Surface Texture Parameters

Modeling of Frictional Stick-Slip of Contact Interfaces Considering Normal Fractal Contact

Effect of Surface Texture on the Tribological Behavior of Sliding Electrical Contact Interface

Research Progress on the Design of Surface Texture in Tribological Applications: A Mini-Review