Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Effect of surface roughness on sliding friction in lubricated contacts-reciprocal experiment study

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Transition of frictional states and surface roughness effects in lubricated contacts

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

Investigation of Normal Dynamic Contact Stiffness and Damping Characteristics in Mixed Lubrication for Non-Gaussian Rough Surfaces

Prediction of Sliding Friction Force of Rough Surfaces in Lubricated Point Contacts

Experimental Study of the Effect of Surface Texturing on the Lubrication Performance in Point Contacts

Effect of Nanoscale Surface Roughness on Sliding Friction and Wear in Mixed Lubrication

Experimental and Numerical Investigations of the Stribeck Curves for Lubricated Counterformal Contacts

Experimental Investigation on Effects of Surface Texturing on Lubrication of Initial Line Contacts

Influence of Nanoparticles in Lubricant on Sliding Contact of Atomic Rough Surfaces—A Molecular Dynamics Study

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

Effect of Surface Texturing on Lubrication Performance of Ball - on - Disc Point Contacts

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Numerical model of boundary lubrication under point contacts

A computer model for sliding friction in lubricated-point contacts

On the Stribeck Curves for Lubricated Counterformal Contacts of Rough Surfaces

Influence of Surface Roughness on the Friction Property of Textured Surface

EFFECTS OF POINT GRINDING SURFACE TEXTURE ON CONTACT AND WEAR CHARACTERISTICS UNDER DRY SLIDING CONDITION