Abstract:In this study, silicon oxide (SiO2) films were deposited by remote plasma atomic layer deposition with Bis(diethylamino)silane (BDEAS) and an oxygen/argon mixture as the precursors. Oxygen plasma powers play a key role in the quality of SiO2 films. Post-annealing was performed in the air at different temperatures for 1 h. The effects of oxygen plasma powers from 1000 W to 3000 W on the properties of the SiO2 thin films were investigated. The experimental results demonstrated that the SiO2 thin film growth per cycle was greatly affected by the O2 plasma power. Atomic force microscope (AFM) and conductive AFM tests show that the surface of the SiO2 thin films, with different O2 plasma powers, is relatively smooth and the films all present favorable insulation properties. The water contact angle (WCA) of the SiO2 thin film deposited at the power of 1500 W is higher than that of other WCAs of SiO2 films deposited at other plasma powers, indicating that it is less hydrophilic. This phenomenon is more likely to be associated with a smaller bonding energy, which is consistent with the result obtained by Fourier transformation infrared spectroscopy. In addition, the influence of post-annealing temperature on the quality of the SiO2 thin films was also investigated. As the annealing temperature increases, the SiO2 thin film becomes denser, leading to a higher refractive index and a lower etch rate.

Effect of sputtering condition on dielectric strength and deposition rate of Al2O3 thin film

Properties of amorphous SiO2 films prepared by reactive RF magnetron sputtering method

Deposition and Characterization of AZO Thin Films on Flexible Glass Substrates Using DC Magnetron Sputtering Technique

Deposition of Dense SiO2 Thin Films for Electrical Insulation Applications by Microwave ECR Plasma Source Enhanced RF Reactive Magnetron Sputtering

Influence of O_2/Ar Flow Ratio on Microstructures and Photoluminescence of ZnO Films

Optimization of Sputtering Parameters for Deposition of Al-doped ZnO Films by Rf Magnetron Sputtering in Ar+H2 Ambient at Room Temperature

Effect of Deposition Temperature on Al2O3 Films Deposited by Atomic Layers Deposition

Effect of O2/(O2+Ar) Ration on Deposition Rate of La-Sr-Mn-O Thin Films Prepared by Magnetron Sputtering

The Effect of RF Power and Working Gases on the Dielectric Properties of Sialon Thin Films

Effect of sputtering power on the microstructure and photelectric properties of Al doped ZnO thin films

Effects of deposition temperature on the mechanical and structural properties of amorphous Al-Si-O thin films prepared by RF magnetron sputtering

Preparation, Characterization, Insulation Study of Al2O3 Thin Film Deposited by Dual Ion Beam Sputtering

On the influence of annealing on the compositional and crystallographic properties of sputtered Li-Al-O thin films

The Influences of High Energetic Oxygen Negative Ions and Active Oxygen on the Microstructure and Electrical Properties of ZnO:Al Films by MF Magnetron Sputtering

Effects of O_2/Ar Ratio at Rated Pressure on Conductivity of Thin ZnO:Al Films

Bias Voltages and Growth of Sputtered Al_2O_3 Films on Polythylene Terephthalate Substrates

The Effect of Oxygen Concentration to DC Magnetron Sputtering ZnO:Al Films

Deposition and Characterization of RP-ALD SiO2 Thin Films with Different Oxygen Plasma Powers

Low-temperature Deposition of Α-Al2o3 Films by Reactive Sputtering Al+α-Al2O3 Target

The Effect of the Process Conditions on the Synthesis of Zirconium-Aluminum Oxide Thin Films Prepared by Ultrasonic Spray Pyrolysis

The Effect of Applied Substrate Negative Bias Voltage on the Structure and Properties of Al-containing A-C:H Thin Films