Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Research on alteration of oil-filled transformer during transformation from 10 kV to 20 kV for power distribution network

Upgrading of 10 Kv Distribution Transformer and Prefabricated Substation to 20 Kv Voltage Level

Switchgear voltage-raise reforming from 10kV to 20kV

Research on AC and High Frequency Breakdown Characteristics of Oil-paper Insulation of 220 Kv Current Transformers

Research on Deterioration Mechanism of Oil-paper Insulation of 220 Kv Current Transformer

Optimization Configuration of High Voltage Reactors in Large Power Grid

Research on the Replacement of Circuit Breaker in 550 kV GIS

Analysis on Insulation Coordination Scheme for ±800 Kv DC Converter Station

Upgrade Study Of High Power Electronics Laboratory For +/- 800kv Uhvdc Valves

ANALYSIS OF ELECTROMAGNETIC FIELDS AND EDDY CURRENT LOSSES IN LARGE POWER TRANSFORMERS

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Research on key issues of insulation coordination for ±1 100 kV UHVDC converter station

Discussion about 20 kV System Client Substation Design

Research on transient overvoltage for converter station of Zhoushan multi-terminal VSC-HVDC project

Research of Neutral Grounding Modes for 20 Kv Distribution Network

DC switching overvoltage of ± 1100 kV UHVDC converter station

Study on Transient Overvoltage of Zhexi Converter Station of ±800 Kv DC Power Transmission Project

On the DC Transient Overvoltage in the Converter Stations of ±800 Kv Xiluodu Zhexi HVDC Project

Overvoltage and insulation coordination for ±1100 kV UHVDC converter station

Study on Neutral-Bus Overvoltage Mechanism of ±500 Kv DC Power Transmission Project from Tianshengqiao to Guangdong

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station